VanWasshenova Thesis: Difference between revisions

From New IAC Wiki
Jump to navigation Jump to search
← Older editNewer edit →
Vanwdani (talk | contribs)
8,078 edits
Vanwdani (talk | contribs)
8,078 edits
Line 15: Line 15:
=====[[Final Lab Frame Moller Electron 4-momentum components in XZ Plane]]=====
=====[[Final Lab Frame Moller Electron 4-momentum components in XZ Plane]]=====
=====[[Final Lab Frame Moller Electron 4-momentum components in XY Plane]]=====
=====[[Final Lab Frame Moller Electron 4-momentum components in XY Plane]]=====
======[[p_{x} and p_{y} results based on Phi]]======
======[[p<sub>x</sub> and p<sub>y</sub> results based on Phi]]======


==[[DV_XSECT|Moller Differential Cross-Section]]==
==[[DV_XSECT|Moller Differential Cross-Section]]==

Revision as of 18:14, 31 May 2017

Introduction

Moller Scattering

Moller Scattering Definition

Variables_Used_in_Elastic_Scattering

DV_Calculations_of_4-momentum_components

Initial Lab Frame 4-momentum components

Initial CM Frame 4-momentum components

Special Case of Equal Mass Particles
Total Energy in CM Frame
Scattered and Moller Electron Energies in CM Frame

Final Lab Frame Moller Electron 4-momentum components

Final Lab Frame Moller Electron 4-momentum components in XZ Plane
Final Lab Frame Moller Electron 4-momentum components in XY Plane
[[px and py results based on Phi]]

Moller Differential Cross-Section

GEANT4 Simulation of Moller Scattering

LH2 Target

Simulation Setup

NH2 Target

LH2 Vs. NH3

Effects Due to Target Material

Target Density

Atomic Mass and Electron Number Effects

Differential Cross-Section Offset

Weighted Isotropic Distribution in Lab Frame

Uniform distribution in Energy and Theta LUND files

Center of Mass for Stationary Target

Phase space Limiting Particles

Determining Momentum Components After Collision in CM Frame

Theta Dependent Components

Phi Dependent Components

Electron Center of Mass Frame

Lorentz Transformation to Lab Frame

Weight

GEMC Simulation

Drift Chamber

Determining wire-theta correspondence

CED Verification of DC Angle Theta and Wire Correspondance

DC Super Layer 1:Layer 1

DC Binning Based On Wire Numbers

Detector_Geometry Simulation

Conic Sections

Circular Cross Sections
Elliptical Cross Sections

Determing Elliptical Components

Determing Elliptical Equations

Test for Theta at 20 degrees and Phi at 0

In the Detector Plane

Test in Plane for Theta at 20 degrees and Phi at 0
Test in Plane for Theta at 20 degrees and Phi at 1 degree

Function for change in x', Lab frame

Wire Number Function

Mathematica Simulation

In the Detector Frame

In the wire frame

Points of Intersection
The Wires
Right Hand Wall
Left Hand Wall
The Ellipse

Plotting Different Frames

Parameterizing the Ellipse Equation

Change in Wire Bin Number

One Hit Per Wire Bin at phi=0

Phi and Theta Limits of wire bins

Detector Occupancy

Whitney Rates

GEANT Moller Simulations

Comparison of GEANT Simulation to Whitney Data

Isotropic Weighted Moller Distribution in GEMC

Retrieved from "https://wiki.iac.isu.edu/index.php?title=VanWasshenova_Thesis&oldid=115467"