Proposals

Priority	task
1	Order target chamber
1	Order 8 tungsten targets, 2 mm thick
1	Order cooling lines for target chamber
1	Order 8 tungsten targets, 2 mm thick
2	Build box to hold target motor controls, pull cables
3	enclose HRRL cavity with 1/4" lead
	check all connectors are in hand for target control
	check camera pulse trigger synchronization
	check beam line alignment , are energy slits centered, is 90degree line going straight through wall
	bolt last flange to girder after last set of quads
	tungsten target holder for rotating target
1	Ta or W re-conversion target for Flag 3
	check flag 2 yag optics & setup, need way to switch internet between cameras so one computer can record images from each separately
	two sets of steering magnets for 90 degree line
	pull cable for FCC signals and fan out to control room and DAQ room
in progress	Check the alignment.
done	Find DAQ hard-wares from Dr. McNalty's lab.
done	Ask Chad to make FC cooler.
in progres	Work on Table design.
in progres	Align YAG at the center of the 5-way cross.
	Check the JAI camera trigger and trig it synchronously with LED.
in progres	Order W-targets -- Just order them online.
done	Order Prosilica camera cable -- Waiting for the confirmation.
in progres	Install beam parts. (Ens, Flag2 Dipole2, Long beampipe, FC2, Flag2 gas.)
	Find W-Target and target holder.
	Find a pipe (or 3-way cross) to replace 5-way cross.
	Install 45-deg Flag to W-target position.

Positrons