Difference between revisions of "CLAS12 R1 Progress Reports"
Jump to navigation
Jump to search
Line 125: | Line 125: | ||
12/3/12 Meeting Notes with Mac and George at ISU | 12/3/12 Meeting Notes with Mac and George at ISU | ||
+ | |||
+ | |||
+ | Construction Proceedures: | ||
+ | |||
+ | Chambers outside cleanroom should have covers to keep dust off buss wires | ||
+ | |||
+ | Cap 113 (Brown one) needs to be replaced on STB board. | ||
+ | |||
+ | Need 2 amp fuse on 5 Volt supply to pre-amps. | ||
+ | |||
+ | |||
+ | Chamber operating procedures | ||
+ | |||
+ | |||
+ | ISU Tasks: | ||
+ | |||
+ | JLab Tasks | ||
+ | |||
+ | 1.) What are the fault conditions on the STB board when the power supply exceeds voltage/current |
Revision as of 22:15, 3 December 2012
The Drift Chamber Wiki at JLab
1) Dial toll free, 866-740-1260 2) Enter the 7 digit Access Code, 6074391, followed by the "#" key.
service httpd start
Clean room Prep
Clean room Construction 2011
Jlab Shipment 8/8/2011
Jlab Stringing Prep
September 2011
October 2011
November 2011
December 2011
January 2012
February 2012
March 2012
ISU - Clean Room Particle Count Log
April 2012
ISU - Clean Room Particle Count Log
May 2012
June 2012
July 2012
August 2012
September 2012
JLab Shipment
October 2012
Potting
Epoxy Ratio 2.33:1 (Epon 828 Resin : Versamid 140).
November 2012
December 2012
12/3/12 Meeting Notes with Mac and George at ISU
Construction Proceedures:
Chambers outside cleanroom should have covers to keep dust off buss wires
Cap 113 (Brown one) needs to be replaced on STB board.
Need 2 amp fuse on 5 Volt supply to pre-amps.
Chamber operating procedures
ISU Tasks:
JLab Tasks
1.) What are the fault conditions on the STB board when the power supply exceeds voltage/current