Difference between revisions of "CLAS12 R1 Progress Reports"
Jump to navigation
Jump to search
| Line 124: | Line 124: | ||
[[201212_R1ProgressRep]] | [[201212_R1ProgressRep]] | ||
| − | 12/3/12 Meeting Notes with Mac and George at ISU | + | ==12/3/12 Meeting Notes with Mac and George at ISU== |
| − | Construction Proceedures: | + | ===Construction Proceedures:=== |
Chambers outside cleanroom should have covers to keep dust off buss wires | Chambers outside cleanroom should have covers to keep dust off buss wires | ||
| Line 135: | Line 135: | ||
Need 2 amp fuse on 5 Volt supply to pre-amps. | Need 2 amp fuse on 5 Volt supply to pre-amps. | ||
| + | Chamber grounding (ground through HV cable) | ||
| − | Chamber operating procedures | + | ===Chamber operating procedures=== |
| − | ISU Tasks: | + | ===ISU Tasks:=== |
| − | JLab Tasks | + | ===JLab Tasks=== |
1.) What are the fault conditions on the STB board when the power supply exceeds voltage/current | 1.) What are the fault conditions on the STB board when the power supply exceeds voltage/current | ||
Revision as of 22:16, 3 December 2012
The Drift Chamber Wiki at JLab
1) Dial toll free, 866-740-1260 2) Enter the 7 digit Access Code, 6074391, followed by the "#" key.
service httpd start
Clean room Prep
Clean room Construction 2011
Jlab Shipment 8/8/2011
Jlab Stringing Prep
September 2011
October 2011
November 2011
December 2011
January 2012
February 2012
March 2012
ISU - Clean Room Particle Count Log
April 2012
ISU - Clean Room Particle Count Log
May 2012
June 2012
July 2012
August 2012
September 2012
JLab Shipment
October 2012
Potting
Epoxy Ratio 2.33:1 (Epon 828 Resin : Versamid 140).
November 2012
December 2012
12/3/12 Meeting Notes with Mac and George at ISU
Construction Proceedures:
Chambers outside cleanroom should have covers to keep dust off buss wires
Cap 113 (Brown one) needs to be replaced on STB board.
Need 2 amp fuse on 5 Volt supply to pre-amps.
Chamber grounding (ground through HV cable)
Chamber operating procedures
ISU Tasks:
JLab Tasks
1.) What are the fault conditions on the STB board when the power supply exceeds voltage/current