Difference between revisions of "TF EIM Chapt9"

From New IAC Wiki
Jump to navigation Jump to search
Line 47: Line 47:
  
  
The above circuit is called an inverting amplifier.  The input signal is applied tp the inverting terminal ("-") of the Op Amp through a resister R_1.  The non-inverting terminal ("+") is grounded.
+
The above circuit is called an inverting amplifier.  The input signal is applied to the inverting terminal ("-", <math>V_1</math>, or<math> V_n</math>) of the Op Amp through a resister R_1.  The non-inverting terminal ("+",<math> V_2</math>, or<math> V_p</math> ) is grounded.

Revision as of 03:00, 13 April 2011

Operational Amplifiers (Op Amps)

The operational amplifier is monolithic (single chip) integrated circuit composed of transistors, resistors, diodes, and other components.

The small package produces a device with small capacitance and inductance which is superior to assembling the equivalent circuit with individual components.


Op-Amp

the "-" sign indicates the inverting input terminal and the "+" indicates the non-inverting input.

A positive going input voltage at the non-inverting ("+") input produces a positive going output.

A positive going input voltage at the inverting ("+") input produces a negative going output.

In other words the output is in phase when the input is non-inverting and 180 degrees out of phase when the input is inverting.

TF EIM GenOpAmp.png


Equivalent circuit

TF EIM GenOpAmp EquivCirct.png


Gain = [math]A_o \equiv \frac{V_{out}}{V_2-V_1} \equiv[/math] Open loop gain = gain when there isn't anything hooked up to the op amp to draw current from it.

Common Mode

Common mode input is defined as the situation where the two inputs are equal ([math]V_1 = V_2)[/math]. In this case[math] V_1[/math] is inverted and will cancel the input [math]V_2[/math] so the output becomes Zero in the ideal Op Amp.


Op Amps usually has two bias supplies in order to produce a high gain as determined by the difference in the input voltages. The output can't be larger than the supply bias.


Differential Op Amp

A single stage differential op Amp can be described as being composed of two bipolar transistors in a common emitter configuration as shown below.

TF EIM BiPolarOpAmp.png

Inverting Amplifier

TF EIM Lab23.png


The above circuit is called an inverting amplifier. The input signal is applied to the inverting terminal ("-", [math]V_1[/math], or[math] V_n[/math]) of the Op Amp through a resister R_1. The non-inverting terminal ("+",[math] V_2[/math], or[math] V_p[/math] ) is grounded.