Difference between revisions of "Rotating Tungsten Target System"
| Line 24: | Line 24: | ||
= STR8 - Step Motor Drives= | = STR8 - Step Motor Drives= | ||
| + | |||
| + | == Document == | ||
[http://www.applied-motion.com/support/downloads?part-number=STR8 STR8 Documents] | [http://www.applied-motion.com/support/downloads?part-number=STR8 STR8 Documents] | ||
| Line 46: | Line 48: | ||
[[Media:STR_speed-torque.pdf]] | [[Media:STR_speed-torque.pdf]] | ||
| + | |||
| + | == Features == | ||
| + | |||
| + | Low cost, digital step motor driver in compact package• | ||
| + | |||
| + | Operates from Step & Direction signals or Step CW & Step CCW (jumper selectable)• | ||
| + | |||
| + | Enable input• | ||
| + | |||
| + | Fault output• | ||
| + | |||
| + | Optically isolated I/O• | ||
| + | |||
| + | Digital filters prevent position error from electrical noise on command signals• | ||
| + | |||
| + | Jumper selectable: 150 kHz or 2 MHz• | ||
| + | |||
| + | Rotary switch easily selects from many popular motors• | ||
| + | |||
| + | Electronic damping and anti-resonance• | ||
| + | |||
| + | Automatic idle current reduction to reduce heat when motor is not moving• | ||
| + | |||
| + | Switch selectable: 50% or 90% of running current• | ||
| + | |||
| + | Switch selectable step resolution: 200 (full step), 400 (half step), 2000, 5000, 12800 or • 20000 steps/rev | ||
| + | |||
| + | Switch selectable microstep emulation provides smoother, more reliable motion in full and • half step modes | ||
| + | |||
| + | Automatic self test (switch selectable) | ||
| + | |||
| + | Operates from a 24 to 75 volt DC power supply | ||
| + | |||
| + | Running current up to 7.8 amps per phase | ||
Revision as of 05:03, 29 March 2012
Parts
[More Images ]
Rotating Union
Positron Target Box
The pipe that go through quads has inner diameter: 47.38 * mm
STR8 - Step Motor Drives
Document
STR8 Manuals:
Media:STR_Quick_Setup_Guide.pdf
Datasheet:
Media:STR_Brochure_925-0002_RevC.pdf
2D Drawing:
Speed-Torque Curves:
Features
Low cost, digital step motor driver in compact package•
Operates from Step & Direction signals or Step CW & Step CCW (jumper selectable)•
Enable input•
Fault output•
Optically isolated I/O•
Digital filters prevent position error from electrical noise on command signals•
Jumper selectable: 150 kHz or 2 MHz•
Rotary switch easily selects from many popular motors•
Electronic damping and anti-resonance•
Automatic idle current reduction to reduce heat when motor is not moving•
Switch selectable: 50% or 90% of running current•
Switch selectable step resolution: 200 (full step), 400 (half step), 2000, 5000, 12800 or • 20000 steps/rev
Switch selectable microstep emulation provides smoother, more reliable motion in full and • half step modes
Automatic self test (switch selectable)
Operates from a 24 to 75 volt DC power supply
Running current up to 7.8 amps per phase