Difference between revisions of "HV-Circuit For TGEM-Detector"

From New IAC Wiki
Jump to navigation Jump to search
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
 
=HV-Circuit Design=
 
=HV-Circuit Design=
 +
 +
Remove RC Trigout circuit from 2nd TGEM stage
 +
 
The HV- circuit for TGEM consists of two boards represented by the following schemes:
 
The HV- circuit for TGEM consists of two boards represented by the following schemes:
 
{| border="1" cellpadding="4"
 
{| border="1" cellpadding="4"
Line 29: Line 32:
  
 
The location of the boards on the chamber:
 
The location of the boards on the chamber:
 +
 +
After removing filter, print out another picture, place resistor in the paper and take another picture.
  
 
[[Image: HV_location.png | 250 px]]
 
[[Image: HV_location.png | 250 px]]

Latest revision as of 20:56, 2 June 2010

HV-Circuit Design

Remove RC Trigout circuit from 2nd TGEM stage

The HV- circuit for TGEM consists of two boards represented by the following schemes:

circuit 1
circuit 2

There are 10 cm X 8 cm boards, the 2nd board are deductible in size a little(instead of 8cm in width, it may reach 5cm), the following represent both of them with all the layers :

board 1
board 2

Boards top layer:

board 1
board 2

Boards bottom layer:

board 1
board 2


There is a little difference between the these schemes and the old ones that I added the filter for each board.


The location of the boards on the chamber:

After removing filter, print out another picture, place resistor in the paper and take another picture.

HV location.png


Go Back