11/1/2013

Confirm signals on all of Sector 5's sense wires
Finish HV burnin: S:F:G = 1500:-750:536 and the current draw is less than 1 uA CLAS12_R1_S5_QA
After the above is completed, stop gas flow, Install dust covers, prepare for shipping
Test TDC integrity using DAQ and S1

11/8/2013: Worked with Haitham on Sector 5; Moved Kraken to SL2; Began confirming signals on S5 sense wires S5 Testing and Performance Summary; Add missing oscilloscope image SL2-STB6-K1200872 U10; Confirmed with Haitham that HV burin is completed for SL2 R1S5_SL2_BurnIn; Rotated Sector 3 with David

11/16/2013: Confirmed signals on S5 SL2 sense wires. Found eight wires not listed in S5 Testing and Performance Summary without signal. Will test again to verify.

Super Layer	STP Board	Wires without any Signal	Notes
SL2	STB1-K1200874	1,4,19
SL2	STB2-K1200875	0
SL2	STB3-K1200873	0
SL2	STB4-K1200869	83
SL2	STB5-K1200871	-	Was unable to get signal on board for any wire. This board is currenty being debugged. All boots out.
SL2	STB6-K1200870	1
SL2	STB7-K1200872	7,19,67,72,82	U67 has a lot of noise.

SL2 has been in HV burnin: S:F:G = 1500:-750:536 and the current draw is 1-2 uA on the sense wires. Has not gone down after a week.

11/21/2013: The 2 Fold HV Power Supply still reading between 1-2 uA. Could be readout on power supply. According to Wiki the burnin for S5 SL2 is complete.; Retested signals on eight wires not listed in Testing Summary for signal that were found without signal. Could get signal on five of the wires checked.

Super Layer	STP Board	Wires without any Signal	Notes
SL2	STB1-K1200874	1,19	Noise, but no signal. U19 has large noise as seen previously on STB7-U67. Putting in missing boot did not change anything.
SL2	STB4-K1200869	-
SL2	STB7-K1200872	7

Weekly progress meeting at 10 am Mondays

AW CLAS12R1