HITs in DC
Before wall padding is taken into effect. Only the limits on phi as a function of theta is considered.
5 to 15 degrees in Theta at Phi 0 with Shield OUT
| Version 2.4 | Version 2.6 |
|---|---|
| GEMC V2.4 Trial Setup Conditions | GEMC V2.6 Trial Setup Conditions |
| GEMC V2.4 JLAB 1.3 Banks | GEMC V2.6 clas12Tags Banks |
| GEMC V2.4 clas12Tags Banks | |
| GEMC V2.4 Bank Comparison | |
| GEMC V2.4 Angle Change | GEMC V2.6 Angle Change |
|
|
| GEMC V2.4 vs V2.6 |
From 5 to 40 in Theta with Phi Isotropic
Shield OUT
| Version 2.4 Shield OUT | Version 2.6 Shield OUT |
|---|---|
| GEMC V2.4 Trial Setup Conditions | GEMC V2.6 Trial Setup Conditions |
| GEMC V2.4 Shield IN/FT ON eg12.gcard | GEMC V2.6 Shield IN/FT ON eg12.gcard |
|
|
|
|
|
|
| Shield OUT GEMC V2.4 vs V2.6 |
FT OFF
| Version 2.4 FT OFF | Version 2.6 FT OFF |
|---|---|
| GEMC V2.4 Trial Setup Conditions | GEMC V2.6 Trial Setup Conditions |
| GEMC V2.4 clas12Tags FT OFF Banks | GEMC V2.6 clas12Tags FT OFF Banks |
|
GEMC V2.6 Sector1 Isotropic FT OFFAngle Change |
|
|
|
|
| GEMC V2.4 vs V2.6 |
FT ON
| Version 2.4 FT ON | Version 2.6 FT ON |
|---|---|
| GEMC V2.4 Trial Setup Conditions | GEMC V2.6 Trial Setup Conditions |
| GEMC V2.4 clas12Tags FT ON Banks | GEMC V2.6 clas12Tags FT ON Banks |
|
GEMC V2.6 Sector1 Isotropic FT ON Angle Change |
|
|
|
|
| GEMC V2.4 vs V2.6 |
insert molller weighted graphs + binned efficiency graph (Recons/Theory), a slice at phi=0 and phi=30 (2-D plot)
insert beamline shielding into g-card and graph rate difference (With shield - no shield) in units of Hz assuming 10 nA and 11 GeV
Shield impact on Moller momentum
Plot Momentum of the Moller electron for both Shield in and Shield out.