PAS Lead Tunnel
Jump to navigation
Jump to search
Made lead brick tube 6/4/2021
Internal measurements of rectangular tube 103mm x 152mm
Plan to model cradle for NaI detector to put crystal in the center of the tube. Crystal is 3in in diameter (yay units)
Hope to 3D print cradle, possible to have one machined too
[[File:|300px|thumb|left|Lead tunnel created on steel table in clean room. Detector will be mounted inside in a cradle ]]
[[File:|300px|thumb|center|Looking down the center of the lead tunnel. Detector will be mounted at the far end ]]
| 700V Plots | |
| [[File:|300px|thumb|left|Lead tunnel created on steel table in clean room. Detector will be mounted inside in a cradle ]] | [[File:|300px|thumb|center|Looking down the center of the lead tunnel. Detector will be mounted at the far end ]] |