R3

A description of the Region 3 (RIII) Design for CLAS12

Conceptual Design

The location of Region III on this drift chamber can be viewed at File:Concept1.pdf

Region III is assembled with 6 Eqi-shaped pieces. Each of these pieces resembles a Pizza slice which together forms the whole chamber. A view of the 6 piece assembly can be found at File:Concept2.pdf

Each of these pieces is made of 3 kinds of plates.

1. Nose Plate (1 No.)

2. End Plate (2 No’s)

3. Face Plate (1 No.)

A Sample assembly of the slice can be found at File:Concept slice.pdf

Nose Plate:

This is the place which forms the base for each slice. Both of the end plates are attached at the ends of this plate. The angled end of the end plates are attached to this nose plate, so that the end plates are projected at an angle in 3-D.

End Plate:

There are 2 end plates for each slice which are attached opposite to each other. There are several holes on each end plate through which sets of sense wires or passed connected both the end plates of a particular slice. Area in which holes are drilled can be divided into 2 areas; upward wire area and Downward wire area. A sense wire from upward wire area of end plate ‘A’ is drawn to the downward wire area in the opposite end plate ‘B’ and vice versa. Both these wires are angled at 6 degrees to the vertical of each slice.

End plate can be found at File:End plate.pdf

Face plate:

Face plate is the top plate which holds the end plate together on the top side.

Image:end_plate_dimensions

Design criteria

The Design Criteria is to develop all the necessary dimensions from the known dimensions.

The known dimensions are

• Distance from target to first sense wire plane along a ray which is normal to the end plate = 4746.5 mm

• Chamber Tilt Angle = 25 Degrees

• Maximum Scattering Angle = 45 Degrees

• Minimum Electron Scattering angle = 5 Degrees

• Distance between the two Adjacent Pieces = 160 mm

The Definition of these given Dimensions can be viewed at File:Given parameters.pdf and at File:Given parameters 2.pdf

Theses known dimensions are used in the determination of the remaining dimensions of the chamber.

Dimensions

End Plate

References

1. R3 status page at JLAB
2. CLAS detector NIM article Media:NIM_A449.pdf
3. Mac's CLAS 12 tracking design writeup May 15 , 2005 Media:CLAS12-5-2005.pdf
4. Mac's CLAS 12 tracking design writeup Jan. 1, 2007 Media:CLAS12-1-2007.pdf