Difference between revisions of "PAS Lead Tunnel"
Jump to navigation
Jump to search
| Line 7: | Line 7: | ||
Hope to 3D print cradle, possible to have one machined too | Hope to 3D print cradle, possible to have one machined too | ||
| − | + | [[File:.png|300px|thumb|none|Lead tunnel created on steel table in clean room. Detector will be mounted inside in a cradle ]] | |
---- | ---- | ||
[[PAS_Experimental_Setup]] | [[PAS_Experimental_Setup]] | ||
Revision as of 03:04, 5 June 2021
Made lead brick tube 6/4/2021
Internal measurements of rectangular tube 103mm x 152mm
Plan to model cradle for NaI detector to put crystal in the center of the tube. Crystal is 3in in diameter (yay units)
Hope to 3D print cradle, possible to have one machined too
File:.png
Lead tunnel created on steel table in clean room. Detector will be mounted inside in a cradle