Difference between revisions of "TF EIM Chapt6"
Line 59: | Line 59: | ||
if | if | ||
− | <math>\ | + | <math>\rho</math> = resistivity of the n-type semiconductor |
then | then | ||
− | :r = <math>\ | + | :r = <math>\rho \frac{\ell}{A}</math> = resistance of the JFET |
:<math>I_D = \frac{V_{DD}}{r+R_D}</math> | :<math>I_D = \frac{V_{DD}}{r+R_D}</math> |
Revision as of 05:01, 5 April 2011
Field Effect Transistors (FET, JFET, MOSFET)
Properties
FETs differ from the bipolar transistors in the las chapter in that the current from a FET is only due to the majority charge carriers in the semiconductor while bi-polar transistors current is produced from both carrier types; electron and hole.
- higher input impedance than bi-polar
- less gain than bi-polar
JFET
JFET
Junction Field Effect Transistor
In a bi-polar transistor you have a depletion region with mixed charge carriers
![]() |
![]() |
![]() |
pnp bi-polar transistor | Equivalence circuit | Circuit diagram |
In the Junction Field Effect Transistor you have a single charge carrier with the minority charge carriers forming a choke point for the majority carrier current flow. It is similar to "pinching" a garden hose when water is flowing through it.
![]() |
![]() |
![]() |
JFET | Equivalence circuit | Circuit diagram |
The semiconductor material of the gate is the opposite of the channel. Here the n-p (or p-n) junction is between the gate and the channel.
The JFET operates by reverse biasing the gate-channel junction (diode) so the gate current doesn't flow in the direction indicated by the circuit diagram symbol. This means that the current through the gate is small (nAmps). As a result the input impedance looking into the gate is high (M
) for the equivalent circuit.The current junction rule is
for the Bi-Polar transistor
FET resistor
The FET acts like a resistor.
Consider the following circuit
Let
the drain driving voltage
= resistor between the drain and V_{DD}
if
= resistivity of the n-type semiconductorthen
- r = = resistance of the JFET
If you reverse bias the gate then the depletion region at the p-n junction expands into the n-type material thereby reducing the cross-sectional area (A) of the channel.
MOSFET
MOSFET
Metal-Oxide-Semiconductor Field Effect Transistor