Revision as of 20:27, 1 April 2011

Alignment

Completion Date	Task
4/29/11	remove HRRL Gun
5/2/2011	Install alignment laser( Khalid's 2'x3' table in HRRL doorway)
5/3/2011	Install rotation and translation stages
5/9/2011	Align zero degree beam line
5/12/2011	Align 45 degree beam line
5/13/2011	Align 90 degree beam line

Align laser through HRRL entrance and exit.
place tanslators
move translator along HRRL direction and position until laser spot doesn't move out of two Iris's at limits of translator breadboard.
Not you are aligned along the HRRL axis
Place mirror on translator and be sure laser beam goes back to HRRL gun.
Rotate stage 45 degrees
Move along translator to center laser as much as possible through the experimental cell wall.

Should we increase the dipole gap? From 3/4" to what?

@@ Line 23: / Line 23: @@
-.) Align laser through HRRL entrance and exit.
+# Align laser through HRRL entrance and exit.
-.) place tanslators
+# place tanslators
-.) move translator along HRRL direction and position until laser spot doesn't move out of two Iris's at limits of translator breadboard.
+# move translator along HRRL direction and position until laser spot doesn't move out of two Iris's at limits of translator breadboard.
-.) Not you are aligned along the HRRL axis
+# Not you are aligned along the HRRL axis
-.) Place mirror on translator and be sure laser beam goes back to HRRL gun.
+# Place mirror on translator and be sure laser beam goes back to HRRL gun.
-.) Rotate stage 45 degrees
+# Rotate stage 45 degrees
-.) Move along translator to center laser as much as possible through the experimental cell wall.
+# Move along translator to center laser as much as possible through the experimental cell wall.
-.)
+#