Difference between revisions of "PAS Lead Tunnel"

Revision as of 03:11, 5 June 2021

Made lead brick tube 6/4/2021

Internal measurements of rectangular tube 103mm x 152mm

Plan to model cradle for NaI detector to put crystal in the center of the tube. Crystal is 3in in diameter (yay units)

Hope to 3D print cradle out of ABS plastic, possible to have one machined out of aluminum too

Lead tunnel created on steel table in clean room. Detector will be mounted inside in a cradle	Looking down the center of the lead tunnel. Detector will be mounted at the far end

@@ Line 5: / Line 5: @@
 Plan to model cradle for NaI detector to put crystal in the center of the tube. Crystal is 3in in diameter (yay units)
-Hope to 3D print cradle, possible to have one machined too
+Hope to 3D print cradle out of ABS plastic, possible to have one machined out of aluminum too
 {| class="wikitable " border="2" style="text-align:center;" |cellpadding="20" cellspacing="1