Difference between revisions of "HV-Circuit For TGEM-Detector"
Jump to navigation
Jump to search
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
=HV-Circuit Design= | =HV-Circuit Design= | ||
| + | |||
| + | Remove RC Trigout circuit from 2nd TGEM stage | ||
| + | |||
The HV- circuit for TGEM consists of two boards represented by the following schemes: | The HV- circuit for TGEM consists of two boards represented by the following schemes: | ||
{| border="1" cellpadding="4" | {| border="1" cellpadding="4" | ||
| Line 29: | Line 32: | ||
The location of the boards on the chamber: | The location of the boards on the chamber: | ||
| + | |||
| + | After removing filter, print out another picture, place resistor in the paper and take another picture. | ||
[[Image: HV_location.png | 250 px]] | [[Image: HV_location.png | 250 px]] | ||
Latest revision as of 20:56, 2 June 2010
HV-Circuit Design
Remove RC Trigout circuit from 2nd TGEM stage
The HV- circuit for TGEM consists of two boards represented by the following schemes:
There are 10 cm X 8 cm boards, the 2nd board are deductible in size a little(instead of 8cm in width, it may reach 5cm), the following represent both of them with all the layers :
Boards top layer:
Boards bottom layer:
There is a little difference between the these schemes and the old ones that I added the filter for each board.
The location of the boards on the chamber:
After removing filter, print out another picture, place resistor in the paper and take another picture.
