Difference between revisions of "PAS Lead Tunnel"
Jump to navigation
Jump to search
| (6 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Made lead brick tube 6/4/2021 | Made lead brick tube 6/4/2021 | ||
| − | + | * Tunnel will need to be torn down and rebuilt as the entire exterior will need to have a layer of BorAl surrounding it. Once optimal operating point for NaI detector has been found, source in/out measurements will be made to determine signal:noise in tunnel. Will repeat the same experiment with the addition of BorAl. | |
| − | + | * Internal measurements of rectangular tube 103mm x 152mm | |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| + | * Plan to model cradle for NaI detector to put crystal in the center of the tube. Crystal is 3in in diameter (yay units) | ||
| + | * Hope to 3D print cradle out of ABS plastic, possible to have one machined out of aluminum too | ||
{| class="wikitable " border="2" style="text-align:center;" |cellpadding="20" cellspacing="1 | {| class="wikitable " border="2" style="text-align:center;" |cellpadding="20" cellspacing="1 | ||
|- | |- | ||
| − | + | | [[File:PAS_Lead_Tunnel_1.jpg|200px|thumb|left|Lead tunnel created on steel table in clean room. Detector will be mounted inside in a cradle ]] || [[File:PAS_Lead_Tunnel_2.jpg|300px|thumb|center|Looking down the center of the lead tunnel. Detector will be mounted at the far end ]] | |
| − | |||
| − | | [[File:| | ||
|- | |- | ||
|} | |} | ||
Latest revision as of 03:15, 5 June 2021
Made lead brick tube 6/4/2021
- Tunnel will need to be torn down and rebuilt as the entire exterior will need to have a layer of BorAl surrounding it. Once optimal operating point for NaI detector has been found, source in/out measurements will be made to determine signal:noise in tunnel. Will repeat the same experiment with the addition of BorAl.
- Internal measurements of rectangular tube 103mm x 152mm
- Plan to model cradle for NaI detector to put crystal in the center of the tube. Crystal is 3in in diameter (yay units)
- Hope to 3D print cradle out of ABS plastic, possible to have one machined out of aluminum too
