Difference between revisions of "TF EIM Chapt5"

From New IAC Wiki
Jump to navigation Jump to search
(Created page with '==Half Wave rectifier== A half wave rectifier is a circuit which passes only half of the input AC waveform. This is accomplished by using the diode's forward drop voltage to "c…')
 
Line 21: Line 21:
  
 
:<math>V_{in} = N_1 \frac{d \Phi}{dt}</math>
 
:<math>V_{in} = N_1 \frac{d \Phi}{dt}</math>
 +
 +
:<math>V_{out} = N_2 \frac{d \Phi}{dt} = V_{Finish} - V_{Start}</math>
 +
 +
 +
The ground is relative for a transfer.  You could use the "Tap" or center post as a ground and either the Start or Finish end
  
 
:<math>V_{out} = N_2 \frac{d \Phi}{dt} = V_{Finish} - V_{Start}</math>
 
:<math>V_{out} = N_2 \frac{d \Phi}{dt} = V_{Finish} - V_{Start}</math>
  
 
==Full wave==
 
==Full wave==

Revision as of 03:51, 23 February 2011

Half Wave rectifier

A half wave rectifier is a circuit which passes only half of the input AC waveform.

This is accomplished by using the diode's forward drop voltage to "clip" the AC signal.


Consider the following circuit

TF EIM Lab10 HW Rectifier.png

The Transformer

TF EIM Transformer.png


A transformer uses inductors/coils to step voltages either up or down based on the ratio of the number of coil turns[math]N_1[/math] and [math]N_2[/math].


Let [math]\Phi[/math] represent the magnetic flux seen by the inductors due to the changing current in the primary.

[math]V_{in} = N_1 \frac{d \Phi}{dt}[/math]
[math]V_{out} = N_2 \frac{d \Phi}{dt} = V_{Finish} - V_{Start}[/math]


The ground is relative for a transfer. You could use the "Tap" or center post as a ground and either the Start or Finish end

[math]V_{out} = N_2 \frac{d \Phi}{dt} = V_{Finish} - V_{Start}[/math]

Full wave