Difference between revisions of "TF EIM Chapt5"

From New IAC Wiki
Jump to navigation Jump to search
Line 27: Line 27:
 
The ground is relative for a transfer.  You could use the "Tap" or center post as a ground and either the Start or Finish end  
 
The ground is relative for a transfer.  You could use the "Tap" or center post as a ground and either the Start or Finish end  
  
:<math>V_{out using Tap} = N_{Tap \rightarrow Finish} \frac{d \Phi}{dt} = V_{Finish} - V_{Tap}</math> = Output voltage between Tap and Secondary
+
:<math>V_{\mbox{out using Tap}} = N_{Tap \rightarrow Finish} \frac{d \Phi}{dt} = V_{Finish} - V_{Tap}</math> = Output voltage between Tap and Secondary
  
 
Where  <math>T_{Tap} =</math> ground
 
Where  <math>T_{Tap} =</math> ground

Revision as of 04:49, 23 February 2011

Half Wave rectifier

A half wave rectifier is a circuit which passes only half of the input AC waveform.

This is accomplished by using the diode's forward drop voltage to "clip" the AC signal.


Consider the following circuit

TF EIM Lab10 HW Rectifier.png

The Transformer

TF EIM Transformer.png


A transformer uses inductors/coils to step voltages either up or down based on the ratio of the number of coil turns[math]N_1[/math] and [math]N_2[/math].


Let [math]\Phi[/math] represent the magnetic flux seen by the inductors due to the changing current in the primary.

[math]V_{in} = N_1 \frac{d \Phi}{dt}[/math] = Input Voltage on the Primary side
[math]V_{out} = N_2 \frac{d \Phi}{dt} = V_{Finish} - V_{Start}[/math] = Output Voltage on the Secondary


The ground is relative for a transfer. You could use the "Tap" or center post as a ground and either the Start or Finish end

[math]V_{\mbox{out using Tap}} = N_{Tap \rightarrow Finish} \frac{d \Phi}{dt} = V_{Finish} - V_{Tap}[/math] = Output voltage between Tap and Secondary

Where [math]T_{Tap} =[/math] ground


Since both coils see the same flux

[math]\frac{d \Phi}{dt} = \frac{V_{in}}{N_1}= \frac{V_{out}}{N_2}[/math]


[math]\frac{V_{out}}{V_{in}}= \frac{N_2}{N_1}[/math]

If [math]N_2 \gt N_1[/math] you have a step UP (Voltage increasing) Transformer

If [math]N_2 \lt N_1[/math] you have a step DOWN (Voltage decreasing) Transformer

Full wave