Difference between revisions of "Reproducibility Shots July 2017"

From New IAC Wiki
Jump to navigation Jump to search
Line 52: Line 52:
 
[[File:Shot170F.png|400px|thumb|left|*Unknown calibration on OSL reader]]
 
[[File:Shot170F.png|400px|thumb|left|*Unknown calibration on OSL reader]]
  
[[File:Shot 1 Back Jul2017.png|400px|thumb|center|*Unknown calibration on OSL reader]]
+
[[File:Shot170B.png|400px|thumb|center|*Unknown calibration on OSL reader]]
  
 
[[File:Shot_1_Front_Back_X_Overlay.png|400px|thumb|left|*Unknown calibration on OSL reader]]
 
[[File:Shot_1_Front_Back_X_Overlay.png|400px|thumb|left|*Unknown calibration on OSL reader]]
Line 58: Line 58:
 
[[File:Shot_1_Front_Back_Y_Overlay.png|450px|thumb|center|*Unknown calibration on OSL reader]]
 
[[File:Shot_1_Front_Back_Y_Overlay.png|450px|thumb|center|*Unknown calibration on OSL reader]]
  
[[File:TriMeV Reproducibility Shot1 07-2017.png|400px|thumb|left|*Unknown calibration on OSL reader]]
+
[[File:Shot170%Diff.png|400px|thumb|left|*Unknown calibration on OSL reader]]
  
[[File:Shot169_Current.png|400px|thumb|center|]]
+
[[File:Shot170_Current.png|400px|thumb|center|]]
  
  

Revision as of 19:46, 1 August 2017

Shot 169

In this experiment, I picked 17 different points on my OSL board to test agreement between two OSLs at the same physical location for the same shot from TriMeV.

I have overlaid X and Y profiles as well as created 3D renderings of the beam profile for the front and back sets of OSLs. Note that it is flat due to the distance at which the board was placed from the end of the accelerator.

Diode diameter: 2"

Diode gap: 1.5"

Al vacuum plate thickness: 5/8"

Ta thickness: 0.020"

Distance to Board: 109 cm

Calculated amount of charge: -2.106e07 C
*Unknown calibration on OSL reader
*Unknown calibration on OSL reader
*Unknown calibration on OSL reader
*Unknown calibration on OSL reader
*Unknown calibration on OSL reader
Shot169 Current.png


Shot 170

In this experiment, I picked 17 different points on my OSL board to test agreement between two OSLs at the same physical location for the same shot from TriMeV.

I have overlaid X and Y profiles as well as created 3D renderings of the beam profile for the front and back sets of OSLs. Note that it is flat due to the distance at which the board was placed from the end of the accelerator.

Diode diameter: 2"

gap: 2.5"

Al vacuum plate thickness: 1/8"

Ta thickness: 0.020"

Distance to Board: 102 cm

Calculated amount of charge:

*Unknown calibration on OSL reader
*Unknown calibration on OSL reader
*Unknown calibration on OSL reader
*Unknown calibration on OSL reader
*Unknown calibration on OSL reader



TriMeV Shot Log