Revision as of 15:54, 14 October 2013

Run list

Scaler channel #2 counts the number of beam pulses

Detector 4 is Beam Left and in ADC channel 7, Ortec Dual Spec amp set to course=10, fine=39, Canberra CFD set to 85 mV lower threshold

Detector 1 is Beam Right and in ADC channel 3, Ortec Dual Spec amp set to course=20, fine=10, Canberra CFD set to 70 mV lower threshold

Run #	Run Duration (s)	Configuration
6488	min s	2->60Hz rep rate, Looking at NaI in shielded cell at -600 Volts, Magnet on Accelerator side deflects electrons, Tungsten target is out, triggering only on the beam gate and looking at ADC channel 3
6489	min s	same as above except: 120Hz rep rate, -500 Volts,
6490	min s	same as above except: 120Hz rep rate, -550 Volts,

FC = Aluminum brick 2" from exit window near NaI detectors

50 Ohm scope termination

@@ Line 15: / Line 15: @@
 |-
 |   6489   ||  min  s  || same as above except: 120Hz rep rate, -500 Volts,
+|-
+|   6490   ||  min  s  || same as above except: 120Hz rep rate, -550 Volts,
 |}