Difference between revisions of "PAS Experiment"
Jump to navigation
Jump to search
| (8 intermediate revisions by the same user not shown) | |||
| Line 19: | Line 19: | ||
= DAQ = | = DAQ = | ||
| + | |||
| + | |||
| + | [[CH_Reading_CODA_Data]] | ||
| + | |||
| + | |||
| + | [[DAQ2_Upgrade_Summer_2021]] | ||
[[CAEN V785N ADC]] | [[CAEN V785N ADC]] | ||
| Line 36: | Line 42: | ||
[[File:Readout Controller Library.pdf]] | [[File:Readout Controller Library.pdf]] | ||
| − | [[File:MastersThesis.pdf]] | + | [[File:MastersThesis.pdf]] By Warren Parsons |
==6/1/21== | ==6/1/21== | ||
| Line 45: | Line 51: | ||
*Second nim bin causing errors with modules when bin is close to full. Could be drawing too much current, Dr. Dale is sourcing new nim bin from IAC to replace. We have extras here but need <math>\pm</math>6V and all tested are either non-functioning or have <math>\pm</math>12V & 24 but no 6V | *Second nim bin causing errors with modules when bin is close to full. Could be drawing too much current, Dr. Dale is sourcing new nim bin from IAC to replace. We have extras here but need <math>\pm</math>6V and all tested are either non-functioning or have <math>\pm</math>12V & 24 but no 6V | ||
| + | |||
| + | =Experiment= | ||
| + | |||
| + | [[PAS_Feasibility_Study_Runs]] | ||
| + | |||
| + | [[CaGaS Phase II]] | ||
=CH_Resources= | =CH_Resources= | ||
[[CH_Code_Repository]] | [[CH_Code_Repository]] | ||
| + | |||
| + | [[CH_Isotope_Table]] | ||
| + | |||
| + | [[CH_ROOT_Nonuniform_Binning]] | ||
= Related Papers = | = Related Papers = | ||
Revision as of 19:55, 23 January 2022
CH Task List
CH_PAS_Master_Timeline
Materials
PAS_Experiment_Attenuation_Measurements
DAQ
CH_Reading_CODA_Data
Readout Controller Configuration
File:Readout Controller Library.pdf
File:MastersThesis.pdf By Warren Parsons
6/1/21
- ADC/TDC readout still not functioning. Dr. Forest is going to work on rebuilding the setup
- I will attempt to hunt down manuals for each module and I will compile them here if found - need to look at Jeff Burggraf's wiki entries as this issue may already have a solution
- Second nim bin causing errors with modules when bin is close to full. Could be drawing too much current, Dr. Dale is sourcing new nim bin from IAC to replace. We have extras here but need 6V and all tested are either non-functioning or have 12V & 24 but no 6V
Experiment
CH_Resources
Related Papers
See google drive for now
Contact me: Harpconn@isu.edu