MiniPrototype SinglesCosmicRuns 2008

Goal

Use singles Cosmic events to measure rate differences between Metalica and Plastica

Apparatus

• Plastica and Metalica are stacked on top of each other. High Voltage and ionization gas are connected in parallel.
• A discriminator is connector to the amplified output (an on board preamp and the VPI Post amp) of sense wire 4.
• The discriminator output is connected to a VME scaler.

Proposed Tests

1. Measure the singles rate as a function of DC high voltage
2. Measure the singles rate as a function of Discriminator Threshold

9-05-2008

The DC high voltage is on. The DC outputs of Plastika and Metalica from sense wire 4 are connected to the Model 777 Octal Variable Gain Amplifier.

HV settings
Wire	Volts
Sense	1450
Field	-725
Guard	725

Scope pictures representing the cosmic signals from Plastika and Metalica(Amplifier is connected)

• Plastika

• Metalica

Rate -vs- Discriminator Threshold

Gas is ArCo2 . 75/25 mixture

HV settings
Wire	Volts
Sense	1700
Field	-850
Guard	850

Threshold (mV)	Metalica (Events/hr)	Plastika (Events/hr)	Coincidence
300	701 [math]\pm \sqrt{\frac{1.04194}{730}}[/math]	627 [math]\pm \sqrt{\frac{1.04194}{653}}[/math]
300	560 [math]\pm \sqrt{\frac{1.01639}{569}}[/math]	570 [math]\pm \sqrt{\frac{1.01639}{579}}[/math]
310	[math]592 \pm 11[/math]	[math]500 \pm 24[/math]
325	[math]528 \pm 65[/math]	[math]465 \pm 30[/math]	32
350	[math]421 \pm 48[/math]	[math]379 \pm 40[/math]
400	[math]305[/math]	[math]235[/math]	31

Gas is ArCo2 . 90/10 mixture

HV settings
Wire	Volts
Sense	1450
Field	-725
Guard	725

The scope picture below was taken to illustrate the noise levels on the DC signals after amplification just before disrimination. Previous measurements suggested that the sense wire signal noise had an RMS of about 10 mV. The phillips amplifier doubles this noise RMS. The amplitude of the noise is about 30 mV.

Threshold (mV)	Metalica (Events/hr)	Plastika (Events/hr)	Coincidence (Event/hr)
100	1915	1912	90
100	2148	1799	36
100	1885	1758	37
100	2012	1912	91
100	1905	1754	25
150	671	588	14
150	645	596	11
150	634	596	19
150	629	563	13
150	634	550	5
175	361	358	20
175	380	329	14
175	396	329	14
175	391	344	10
200	286	256	25
200	291	232	4
200	291	251	6
225	183	168	4
225	193	180	6
250	122	120	2
300	93	88	2
350	74	60	3

Threshold (mV)	Metalica (Events/hr)	Plastika (Events/hr)	Coincidence (Event/hr)
100	[math]1973 \pm 98[/math]	[math]1827 \pm 71[/math]
150	[math]643 \pm 15[/math]	[math]583 \pm 17[/math]
175	[math]382 \pm 13[/math]	[math]340 \pm 12[/math]
200	[math]289 \pm 2[/math]	[math]246 \pm 10[/math]
225	[math]188 \pm 5[/math]	[math]174 \pm 6[/math]
250	122	120
300	93	88
350	74	60

With preamp and Post amp on

Sense wire #4 from Metalica comes out of VPI post amp channel #10. VPI channel #15 goes into ADC channel #3

Sense wire #4 from Plastika comes out of VPI post amp channel #15. VPI channel #15 goes into ADC channel #6

Voltage on preamp is 6.0 V.

HV settings
Wire	Volts
Sense	1500
Field	-750
Guard	750

Compare Phillips output and VPI postamp output

Noise level of Plastika and Metalica. The moise on the Phillips amp went from 10 mV to 100 mV due to the voltage applied to the preamps. If you turn the preamp power supply off the noise will go back to ~20 mV.
Plastika

Metalica

16-05-2008

HV settings
Wire	Volts
Sense	1500
Field	-750
Guard	750

The Voltage on the PreAmp is 6.3 Volts

Metalica

Plastika

Threshold(mV)	Metalica (Events/hr)	Plastika (Events/hr)	Metalica (Events/hr)VPI PostAmp	Plastika (Events/hr)VPI PostAmp
150	5828	8172	10021	18673
150	5545	8008	9295	17751
200	1592	2276	3922	6559
200	1547	2163	3854	2163
250	593	747	973	1719
250	593	661	925	1640
250	522	610	951	1592
300	296	339	426	585
300	282	339	413	615
300	314	291	411	626
400	130	159	285	269
450	86	97	151	152
500	53	71	92	107
550	40	50	77	96

Threshold(mV)	Metalica (Events/hr)	Plastika (Events/hr)	Metalica (Events/hr)VPI PostAmp	Plastika (Events/hr)VPI PostAmp
150	[math]5687 \pm 141[/math]	[math]8090 \pm 82[/math]	[math]9658 \pm 363[/math]	[math]18212 \pm 461[/math]
200	[math]1570 \pm 23[/math]	[math]2220 \pm 56[/math]	[math]3888 \pm 34[/math]	[math]4361 \pm 2198[/math]
250	[math]569 \pm 33[/math]	[math]673 \pm 56[/math]	[math]950 \pm 20[/math]	[math]1650 \pm 52[/math]
300	[math]297 \pm 13[/math]	[math]323 \pm 23[/math]	[math]417 \pm 7[/math]	[math]609 \pm 17[/math]
400	130	159	285	269
450	86	97	151	152
500	53	71	92	107
550	40	50	77	96

2-06-2008

HV settings
Wire	Volts
Sense	1450
Field	-725
Guard	725

The Voltage on the PreAmp is 6.3 Volts

Metalica

Plastika

Threshold(mV)	Metalica (Events/hr)	Plastika (Events/hr)	Metalica (Events/hr)VPI PostAmp	Plastika (Events/hr)VPI PostAmp
50	39635	38282	15459	17624
50	37759	22176	15555	15898
50	37858	9758	15536	15666
50	35340	8819	15160	1528
100	1014	1556	1236	4076
100	1120	1713	1280	4145
100	1091	1728	1200	4200
100	1055	1476	1290	4126
150	369	513	393	1337
150	362	585	373	1293
150	460	778	352	1363
150	371	576	413	1442
175	232	363	222	803
175	299	428	239	835
175	205	343	230	752
175	186	318	215	704
200	183	241	144	401
200	116	198	138	401
250	95	141	104	205
300	39	59	52	69
350	25	44	38	39
350	21	37	37	38
400

Threshold(mV)	Metalica (Events/hr)	Plastika (Events/hr)	Metalica (Events/hr)VPI PostAmp	Plastika (Events/hr)VPI PostAmp
50	[math]37648 \pm 1527[/math]	[math]19753 \pm 11928[/math]	[math]15428 \pm 159[/math]	[math]16279 \pm 783[/math]
100	[math]1070 \pm 40[/math]	[math]1618 \pm 106[/math]	[math]1252 \pm 36[/math]	[math]4137 \pm 44[/math]
150	[math]391 \pm 40[/math]	[math]613 \pm 99[/math]	[math]383 \pm 23[/math]	[math]1359 \pm 54[/math]
175	[math]231 \pm 43[/math]	[math]363 \pm 41[/math]	[math]227 \pm 9[/math]	[math]774 \pm 50[/math]
200	[math]150 \pm 34[/math]	[math]220 \pm 22[/math]	[math]141 \pm 3[/math]	[math]401 \pm 0[/math]
250	[math]95[/math]	[math]141[/math]	[math]104[/math]	[math]205[/math]
300	[math]23 \pm 2[/math]	[math]40 \pm 3[/math]	[math]37[/math]	[math]38[/math]
400

6-06-2008

HV settings
Wire	Volts
Sense	1400
Field	-700
Guard	700

The Voltage on the PreAmp is 6.3 Volts

Metalica

Plastika

Go Back