Lab 10 TF EIM

From New IAC Wiki
Jump to navigation Jump to search

Unregulated power supply


Use a transformer for the experiment.

here is a description of the transformer.

File:TF EIM 241 transformer.pdf


Half-Wave Rectifier Circuit

1.)Consider building circuit below.

TF EIM Lab10 HW Rectifier.png

Determine the components needed in order to make the output ripple have a [math]\Delta V[/math] less than 1 Volt.

List the components below and show your instructor the output observed on the scope.

Full-Wave Rectifier Circuit

TF EIM Lab10 FW Rectifier.png

Determine the components needed in order to make the above circuit's output ripple have a [math]\Delta V[/math] less than 0.5 Volt.

List the components below and show your instructor the output observed on the scope.

Full-Wave Rectifier Bridge Circuit

TF EIM Lab10 HW RectifierBridge.png


1.) Choose R in the above circuit so the low-pass filter breakpoint is less than 60 Hz.

2.) Measure the quantities below using at least 4 different load resistors.


[math]R_L[/math] [math]I_L[/math] [math]P_L[/math] [math]V_D[/math] [math]V_{ripple}[/math]

[math]P_L[/math] = power dissipated by the load resistor (don't exceed resistor power rating) [math]V_D[/math] = output voltage

3.) Explain why the ripple amplitude increases as I_L increases.

Forest_Electronic_Instrumentation_and_Measurement