Difference between revisions of "LB SageBrushWork PostDefense"

From New IAC Wiki
Jump to navigation Jump to search
Line 13: Line 13:
 
[[File:LB 50 Percent SeSage TimeCutInfo.png|200px]]
 
[[File:LB 50 Percent SeSage TimeCutInfo.png|200px]]
  
 +
This seems a little sloppy, lets try a 1D histogram instead to see if the cuts are more clear
 +
 +
ROOT Command: MPA->Draw("evt.Sec>>hist","ADCid==1","");
 +
 +
This produced the histogram below
  
 
==0.1% Sage/Se Mixture Time Cuts==
 
==0.1% Sage/Se Mixture Time Cuts==

Revision as of 18:53, 27 August 2018

Time Cuts

The first step in the PAA process is to identify the time cuts used for the split run. This must be done for all samples (50%,10%,0.1%, and 0.04%) Let's do the 50% sample first

50% Sage/Se Mixture Time Cuts

The 50% Se/Sage mixture was measure on Detector B (unshielded, so watch the SNR) on 5/24/17 for a total of 2130.540 seconds. The outer pure witness Se was measure first, and sub-run was roughly 300 seconds for the samples of interest, and 60 seconds for the Co-60 flag. The root command used to draw the timing information was

TTree* tree = MPA;

MPA->Draw("evt.Chan:evt.Sec>>hist2","evt.ADCid == 1");

which produced the histogram below

LB 50 Percent SeSage TimeCutInfo.png

This seems a little sloppy, lets try a 1D histogram instead to see if the cuts are more clear

ROOT Command: MPA->Draw("evt.Sec>>hist","ADCid==1","");

This produced the histogram below

0.1% Sage/Se Mixture Time Cuts

The 0.1% Se/Sage mixture was measured on Detector A (shielded) on 5/24/17 for a total of 2130.540 seconds. The mixture was measured first, and a sub-run was roughly 300 seconds for the Se samples and 60 seconds for the Co-60 flag. The root commands used were

TTree* tree = MPA;

MPA->Draw("evt.Chan:evt.Sec>>hist2","evt.ADCid == 0");

which produced the histogram below

0 1 Percent SeSage TimeCutInfo.png