Difference between revisions of "IAC positron beamline"
| Line 28: | Line 28: | ||
[[Image:IAC_25MeV_QuadDoublet_Label_11-08-07.jpg | 50 px ]] | [[Image:IAC_25MeV_QuadDoublet_Label_11-08-07.jpg | 50 px ]] | ||
| + | |||
| + | Quad doublet size: | ||
[[Image:QuadDoublet_Width.jpg |200 px]] | [[Image:QuadDoublet_Width.jpg |200 px]] | ||
Revision as of 23:42, 5 December 2007
296 cm = parrallel Distance From the end of the accelerator module (After RF cavities) to experimental cell port
280 cm = Distance From accelerator zero degree beamline to Experimental Cell Wall
This picture shows you the current 90 degree bend into the experimental hall. Quad 1 and Quad 2 are shown and then the 2nd Dipole magnet (labeled Bending Magnet 2A a.k.a. Dipole 2) begins after Quad 1 and Quad 2. Dipole 2 is following by another Quad doublet and then a Dipole (Dipole 3) and then a final quad doublet before going through the wall into the experimental cell.
Length of Iron =
Diameter of Coils=
The next picture was taken upstream of the 90 degree bend and shows Dipole 1 which is usually off unless we want to bend beam right into the accelerator hall instead of going straight to Quad 1 and Quad 2.
Label on side of Dipole 1
Label on side of Dipole 2
The Quad doublets in the current beam line have the following label.
Quad doublet size:
We also have Quad triplet which take up less space than the doubles.
