IAC data analysis for GEM

03/26/15

Electronics Setup

PS-ADC, QDC and TDC were used for this experiment. The collected data for GEM was discriminated by CFD and its output was in coincidence with beam gun signal, which became an input for gate generator for QDC and PS-ADC and stop for the for the TDC. (TDC setup was in a common start and beam gun signal was the starter).

The picture above shows the time frame of the pulses relative to each other. The beam gun RF signal was earliest in time, then the beam electron's signal came after 200 ns, and finally GEM's analog signal, with a rise time of about 200 ns, as it was in time with the TDC stop pulse that had a pulse width of about 50 ns.

GEM had a cathode voltage of V=3.5 kV, and 2.8 kV for the potential divider circuit for a triple GEM preamplification.

data Analysis

8851 qdc channel 4, TDC 23 before run8859 switch to 29 , PDC 13.

runs expected to have good in info :8850 8858 8875, 8876,

shutter closed: 8877 (without target).8878

GO BACK [1]