Difference between revisions of "Gumstix Installation"

From New IAC Wiki
Jump to navigation Jump to search
Line 32: Line 32:
  
 
;Voltage supply
 
;Voltage supply
 +
 +
{| border="1"  |cellpadding="20" cellspacing="0
 +
|-
 +
| Gum adapter || Voltage supply
 +
|-
 +
| <math>V_{cc}</math> || <math>out^+</math>
 +
|-
 +
| <math>V_{ground}</math>|| <math>out^-</math>
 +
|}
  
 
Gum adapter(<math>V_{cc}</math> && <math>V_{ground}</math>) should be connected to the voltage supply(~2.5 Volts).
 
Gum adapter(<math>V_{cc}</math> && <math>V_{ground}</math>) should be connected to the voltage supply(~2.5 Volts).

Revision as of 22:01, 20 July 2009

Establishing Connection with Gumstix

The serial connection with Gumstix can be established through the C-kermit or minicom. You can find instructions on the following web pageserial.

Correct alignment of the TTL RS232 adapter

Make sure that the TTL RS232 adapter is connected correctly and red(shows that gumstix is connected) and yellow(serial cable) lights are On.

Gumstix username: root
Password:c0d/\2.0


[math]I^2C[/math] Connection

Connecting to the little board(i2c board)

Cable side Gumstix side
Blue Yellow
White/Green Red
White Green
Green Blue


On Gumstix:

BreakOutGumstix 5.jpg

Voltage supply
Gum adapter Voltage supply
[math]V_{cc}[/math] [math]out^+[/math]
[math]V_{ground}[/math] [math]out^-[/math]

Gum adapter([math]V_{cc}[/math] && [math]V_{ground}[/math]) should be connected to the voltage supply(~2.5 Volts).

BreakOut Box

From Gum adapter using network cable establish connection with BreakOut box.