Fission fragment trasport out of U-233

From New IAC Wiki
Jump to navigation Jump to search

U-233 Coating

The fission chamber has a fissionable material as a neutron sensitive target. The fission chambers have usually target material that make them sensitive for neutrons that belongs to an energy range, the most commonly used material for detecting thermal neutron is U-235, in case of fast neutron Th-232 and U-238 represent good target. In some cases the fission chamber may contain more than one target to detect a wide range of emitted neutrons.<ref name= "Andriamonje"> Novel Micromegas Detector for In-Core Nuclear Reactor Neutron Flux Measurements </ref>

In this research, the neutron sensitive material used in the fission chamber is Uranium 233(U-233). U-233 has a relatively high neutron fission cross section in the energy range of 0.1-30 MeV as shown in the figure below.

U-233 fissionxsection 0.01-100MeV.gif


U-233 fissionxsection fullenergyrange.gif

The coating is on a circular metal plate which is in a direct contact to the cathode. The coating of U-233 has a circular shape of an inch in diameter and 20-40 um in thickness. The U-233 circular plate is glued to a square FR4 copper clad plate of length of 12 cm and thickness of 1 mm (cathode), the plate has a hole of 4 cm in diameter that keeps the U-233 coating exposed to the chamber gas.

Probability of a fission fragment to create a signal

U-233 is relatively sensitive but the coating thickness may stop the fission fragments. Compared to the other neutron sensitive targets, U-233 is relatively sensitive to a wide energy range of neutrons, the range may extend from 0.1 MeV to more than 30 MeV. However, coating thickness determines the if a fission fragment can escape from its surface and to cause an ionization in the gas to create a signal. The range of a fission fragment is calculated in UO3, of thickness 0.1 um and density 7.29 g/cm^3, is 12.07 +_ 0.09 um, <ref name = Hudler> J.C. hadler, Radiation Measurements Vol 43 (2008) pf S334-S336</ref> assuming the fission fragment mobility is the same as the UO3. As the thickness increases more than 0.1 um, the range will decrease according to the following equation <ref name = Hudler/> :

[math] R= R_T - \lt r\gt [/math]

[math] \lt r\gt = \frac{ln(d/R_T) + 0.5}{ 2/d (1-R_T/d) + R_T^{-1}} [/math]


Producing free electrons in the gas will concequienty create a signal. Although the fission fragment leaves the surface of U-233 coating and ionizes the gas, but minimum 200 electrons of energy around 20 eV become free through the fissin fragment's track in the U-233 coating of thickness 1-10um. <ref name = Wang> Wang Jin et al, Applied Physics Letters, Vol 82, 20 (2003) pf 3553-3555</ref>


20eV electrons ff inUO2.png






<references/>