CLAS12 R1
Time line
| Start Date | Description |
| Chamber Stringer Design | |
| Chamber StringerConstruction | |
| Chamber Stringerr Delivery | |
| 5/8/09 | Clean Room Setup |
| 6/8/09 | Chamber Parts delivered, wires, endplates, backplate, nose plate, feedthroughs. mylar window, |
| 6/8/09 | Wire tension apparatus in place |
IAC Facility
Below is a picture of the current conference room at the IAC which will be removed and replaced with a clean room very similar in design to ODU's.
16' high 26 ' deep 17 ' wide
5 ton crane capacity
ODU's current clean room size:
high deep wide
CLAS 10,00 clean rooms
Door:
9'8" high 12' wide
Environmental control needed
Temperature control constraint is
Humidity control: 55 % or less
R1 Construction preparations
Discussion items
1.) Budget
- JLab to ISU travel for JLab personnel to inspect operations
- shipping container for R1 chambers
2.) Clean room
cost =
assume we copy the ODU clean room
Using IAC conference room space, need to remove carpet and paint floor.
3.) hiring timeline
9/08 NSF proposal submission
4.) stringing platform and DC stringing support arm
5.) Manpower
6.) MOU to support post doc request or faculty release time
7.) Stringing equipment
a.) crimping tool
b.) glue
c.) wire or feedthroughs?
d.) wire tension measurement (PC, Magnets, associated electronics
A few pictures ff the R1 fullo size proto type from my JLab visit on 9/16/07. It is about 6 feet tall. CLAS12_R1_Prototype_9-16-07
The air actuated crimping tool:
