Alpha Ionization

Alpha Particles ionization simulation using GEANT4

GEANT4 simulates the ionization of alpha particles in Ar/CO2 90/10 gas. Geant4 can simulate the ionization process for alpha particles. Unfortunately the value of the step function underestimates the number of delta electrons. This is an issue even after decreasing the step cut to 1 nm. Also, using GEANT4 overestimates the range of alpha particles in Ar/CO2 gas when compared to those that srim calculates File:Alpha range ArCo2.txt, the following table shows the maximum range of alpha particles that are emitted from the U-233, and the ranges calculated by srim.

Alpha Energy (MeV)	G4 Range (cm)	Srim Range (um)
1.0	0.56599	129.49
2.0	1.1467	255.91
3.0	1.9024	417.27
4.0	2.8012	612.45
5.0	3.8425	839.91

Based on the previous table, GEANT4 failed to calculate the expected alpha range for most alpha energies, and underestimated the number of alpha's delta electrons emitted through that range.

Calculating the number of the delta electrons without using GEANT4

There is another way to calculate the number of delta electrons without using GEANT4. It starts by calculating the average energy loss [math] \Delta E_a[/math] by the alpha particles and the average energy loss per unit length [math] {\zeta} [/math] in Ar/CO2 gas using the Bethe-Block equation. It then uses the the following equation:

[math] \lambda = \frac{ \Delta E - \Delta E_a}{\zeta} [/math]

to calculate the actual energy loss by ionization [math] \Delta E [/math], where [math] \lambda [/math] represents random landau number.

By dividing the energy loss by the minimum energy for producing a pair of ion/electron pair W, this equation yields the number of electrons emitted by ionization.

Srim can simulate the motion of an alpha particle in Ar/CO2 gas by allowing for the change in the stopping power per unit length. It can also show the ionization energy loss as shown in the following figure:

This figure shows the ionization energy loss of 999 alpha particles as they pass through Ar/CO2 gas, it shows the maximum range is 0.85 mm, by integrating the area under the curve, then dividing by (W*1000) will give the number of delta electrons produced by an alpha particle.