Difference between revisions of "201401 R1ProgressRep"
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
| − | + | =1/6/14= | |
| − | + | Lifted 3 chambers out of the basement and put them on the ISU, temp controlled, loading dock. | |
| − | |||
| − | |||
| − | |||
| + | =1/8/14= | ||
| − | + | Loaded truck for shipment to JLab. | |
| − | 1 | + | =1/13/14= |
| − | |||
| − | |||
| − | + | 3 chambers arrived at JLab and were unloaded. No obvious damage was reported. | |
| − | + | ||
| + | |||
| + | ;Lessons for the next shipment | ||
| + | # trim crate at least 1/2" so there is more space between the trailer wall and the crate. The 91" inch pallets were fine, need to cut a little straighter as a matter of pride and to make it easier to push onto the trailer. | ||
| + | #be sure to cut out a section of the 3x3s so there is room for a pallet jack. | ||
| + | #be sure white pallet drift chamber wheel blocks are at the proper locations so the chambers are aligned with the pallet. Distance between blocks is less important since U-bolts holding the front wheel can be moved back, but not forward. Error may only be accommodated if the space between the front block and rear is shorter than needed. | ||
| + | #Be sure to lift pallets with crane when pallets can't fit through the elevator | ||
| + | #Continue to stage drift chamber on the loading dock, the other pallets can be placed outside, may need to secure a location for the other pallets that contain the A-frames, magnets, and other stuff, the non-drift chamber items can be shipped in a separate shipment. | ||
| + | |||
| + | =1/17/14= | ||
| + | |||
| + | Schedule | ||
Revision as of 17:12, 17 January 2014
1/6/14
Lifted 3 chambers out of the basement and put them on the ISU, temp controlled, loading dock.
1/8/14
Loaded truck for shipment to JLab.
1/13/14
3 chambers arrived at JLab and were unloaded. No obvious damage was reported.
- Lessons for the next shipment
- trim crate at least 1/2" so there is more space between the trailer wall and the crate. The 91" inch pallets were fine, need to cut a little straighter as a matter of pride and to make it easier to push onto the trailer.
- be sure to cut out a section of the 3x3s so there is room for a pallet jack.
- be sure white pallet drift chamber wheel blocks are at the proper locations so the chambers are aligned with the pallet. Distance between blocks is less important since U-bolts holding the front wheel can be moved back, but not forward. Error may only be accommodated if the space between the front block and rear is shorter than needed.
- Be sure to lift pallets with crane when pallets can't fit through the elevator
- Continue to stage drift chamber on the loading dock, the other pallets can be placed outside, may need to secure a location for the other pallets that contain the A-frames, magnets, and other stuff, the non-drift chamber items can be shipped in a separate shipment.
1/17/14
Schedule