Beam Test Jul 5 2012
Preparation
0. MATLAB emittance analysis: (working?)
1. Magnets: --
2. Camera: (a)--Working, (b)--shielding-good,(c) Sync? --
3. Flags: --
4. Farady Cup: hocked up? --
5. Blank off for camera on? --
6. Gas bottle for valve full? --
7. Gas bottle for flags full? --
8. 3 Pickup Coils (Green Torroids):
9. Energy slit working?
10. Three Faraday cups working?
Run Plan (Goal)
General goals are: 1. To find settings for different energies; 2. To find out each beam elements are working properly. 3. Deliver the beam to 0 degree, then 45 degree and 90 degree beamline. Observe them with Faraday cup at 0, 45 and 90 degrees and record settings.
Run list
Do the following for different energies. Start from 10 MeV, the do 3 MeV, then Do 15 MeV etc.
1. Deliver the beam to 0 degreebeamline
Use 0 deg Faraday cup to observe electron beam current.
2. Deliver the beam to 45 degree beamline
1. Observe the beam using Energy slits' two jaws.
2. Observe the beam using 45 degree Flag with YAG target.
3. Observe the beam using 45 deg Faraday cup.
4. Change the width of the slits and see the change in the slit jaw currents and 45 Faraday cup signals.
3. Deliver the beam to 90 degree beamline
Use 90 deg Faraday cup to observe electron beam current.