HRRL OTR Test Mar 3rd 2011

Preparation

JAI Camera Setup

Target in:

Target out:

Target in after shielded:

Objectives

Determined if the steering magnets of the gun are connected to power supply

1. Physically check looking at wires.

2. Change currents on the steering magnet, and observe position of the beam spot. If changes then, connected.

Tune beam using Linac optics only

Chad will tune up the beam using steering elements which are within the HRRL Linac only.

Determined if the OTR target is centered on the beam line

With all beam line magnets off, observe the beam spot at the OTR target. If the beam is centered on the OTR target, then OTR target MAY be centered on the beam line.

Polarization test

Insert a polarizer film. Take several picture for different orientations without changing beam properties.

Angel is measured with respect to:

Polarizer Angel	Iamge
200 px	200 px

Determined if the quads are centered on the beam line

Turn off all the power supplies for the quads.

Turn on Quad closesst to HRRL

If the beam deflects, try to align quad so there is no deflection

Turn on Quad closest to OTR target

If the beam deflects, try to align quad so there is no deflection

Back to Positrons