Gumstix
Hardware
(2)The gumstix motherboard has a 600MHz Marvell XScale processor, 128MB of RAM, and 32MB of flash.
(2)The 80 pin expansion socket is attached to a network interface card for TCP/IP networking.
(3)The 60 pin expansion socket has a breakout-vx card to allow access to the I2C signals, serial ports, and various other GPIO possibilities.
(2)Additionally, 4V power adapters
(10)screw and spacer kits are needed.
(2)TTL to serial adapters
Software
I2C installation
cgi-bin programs
Boa Webserver is the webserver on the Gumstix.
cgicc is the C++ library used for handling web scripts.
Buildroot is the system used to build the root image for the gumstix.
Tutorials
I2C Linux from userspace.
[http://www.yolinux.com/TUTORIALS/LinuxTutorialC++CGI.html libcgicc
Misc
Setting the date
The busybox date -s accepts a very limited format. Use it from another Linux box as follows:
ssh root@134.50.203.56 "echo date -s `date +%m%d%H%M%Y`"
Setting Static IP adress
Use the static method modifiy the file tc/network/interfaces so it says
# /etc/network/interfaces -- configuration file for ifup(8), ifdown(8) # The loopback interface # auto lo iface lo inet loopback # # Wired interfacesq # auto eth0 iface eth0 inet static address 129.57.36.61 #network 129.57.1.0 gateway 129.57.36.1 netmask 255.255.252.0 broadcast 129.57.39.255 # if netduo attached uncomment lines below #auto eth1 #iface eth1 inet dhcp #
Then do commands
ifdown ifup eth0 </ore> Must check the if address of a machine which is connected to the same network by ifconfig and route -n ifconfig interfaces inet addr >>> address Bcast >>> broadcast route -n Genmask >>> netmask Gateway >>> gateway