CH Weekly Reports

09/19/22

• Investigated non-linearity of peak sensing ADC due to issues arising in energy calibrations and efficiency measurements.

• Modified existing calibration code to use non-linear regression to account for ADC.

• Sourced material needed for CaGaS Phase II setup.

• Calculated ADC dead time for live-time correction to efficiency measurement count rates and calculated dead time per experiment.

• Designed holder for Gd foils needed for CaGaS Phase II experiment. To be 3D printed and tested for tolerances.

09/26/22

• Printed both parts of the Gd foil holder for CaGaS Phase II.
  • Parts fit together adequately considering they're 3D printed and not machined.
  • M3 bolts threaded through first part of the holder.
  • M3 nuts pressed into the second part of the holder.
  • Parts printed out of PETG plastic with low density infill (10%).

• Edited rebinning code for energy calibrations for data sets collected with ADC to account for changes in calibration code.
  • Energy calibration script now uses 2nd order polynomial regression to account for nonlinearity of ADC
  • The coefficients from the regression are passed to another script to rebin ADC data from channel to energy, preserving bin count, but bin width will increase as a function of energy.
    • End goal is to pass coefficients into rebinning function and draw energy calibrated plot in the same script.

• Designed Gd₂O₃ powder holder for CaGaS Phase II.
  • Have spray on clear coat to seal plastic after printing is complete in hopes that powder will not stick between printed layers when used.

• Documented Gd holders in wiki with rendered images and a description of intended use.

• Continued to research live time correction for HPGe count rates and think I have applied the correction correctly at the initial measurement level, which will be propagated through to efficiency calculations.

• Researched and tested different integration methods for more accurate measurement of counts in energy peak to compare to Gaussian fit.

• Created tentative list of committee members with major advisor for PhD proposal defense and future dissertation defense.

10/03/22

• Sat in on 30 minute proposal defense presentation by another Ph.D. candidate.

• Began the 3D print of Gd₂O₃ holder for CaGaS Phase II.

• Working with ISU Environmental Health & Safety to set up time to treat and coat lead bricks to build CaGaS Phase II setup.
  • Air monitoring and respirators are required per ISU EH&S safety protocols.

Previous Page

PAS Experiment