First Board for Beam Profile

From New IAC Wiki

Revision as of 19:55, 31 October 2017 by Harpconn (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Jump to navigation Jump to search

Board is separated into two inch squares with mounts for an OSL at each intersection, allowing for a total of 169 OSLs to be fitted per run

Close up of the mounting nails and center of the board. Nails are positioned such that the center of the OSL is on the intersection, allowing for easy symmetry

Holes are drilled into the board to allow dose sticks to be attached to the back of the board

OSLs loaded for the first run to determine beam profile

Distance from the beam end to the board

Board fully loaded and prepared to be mounted in front of accelerator

Fully loaded array at 50cm. Full array holds 191 OSLs

Retrieved from "https://wiki.iac.isu.edu/index.php?title=First_Board_for_Beam_Profile&oldid=119216"