Reproducibility Shots July 2017
Jump to navigation
Jump to search
Shot 169
In this experiment, I picked 17 different points on my OSL board to test agreement between two OSLs at the same physical location for the same shot from TriMeV.
I have overlaid X and Y profiles as well as created 3D renderings of the beam profile for the front and back sets of OSLs. Note that it is flat due to the distance at which the board was placed from the end of the accelerator.
Diode diameter:2"
gap: 1.5"
Al vacuum plate thickness: 5/8"
Ta thickness: 0.020"
Distance from the Ta plate to the center of Ti rolled edge: 110 cm
Diode current vs time: see attached file
