DV RunGroupC Moller

From New IAC Wiki
Jump to navigation Jump to search
need to insert moller shielding into card after moller LUND file is created. (see clas12/beamline)

Simulating the Moller scattering background for EG12

GEANT4 Simulation of Moller Events

Determine the Moller background using an LH2 target to check the physics in GEANT4

Incident electron energy varies from 1-11 GeV.

LH2 target is a cylinder with a 1.5 cm diameter and 1 cm thickness.

  (Following dimensions listed on page 8 of File:PHY02-33.pdf)

Numbers Moller electrons per incident electron.

  While 2nd and 3rd generations are created, only 2 2nd generation daughter particles are created for 1E6 incident particles.  All knock on electrons are not counted.

Momentum distributions in the Lab Frame.

FnlMom.pngMolMom.png

Momentum distributions in the Center of Mass Frame.

Estimated Momentum Distribution

DV_Calculations_of_4-momentum_components

For an incoming electron with momentum of 11GeV, we should find the momentum in the center of mass to be around 53 MeV which is confirmed in the the data/plots.


KEi Pxi Pyi Pzi xi yi z1 KEf Pxf Pyf Pzf xf yf zf KEm Pxm Pym Pzm xm ym zm
11000 0 0 11000.5 0 0 -510 10999.1 0.433025 -0.858867 10999.6 0 0 -509.276 0.905324 -0.433025 0.858867 0.905366 0 0 -509.276

Changing the code for the total Energy to [math]E=(p_1^2+m_1^2)^{1/2}[/math] in the lab frame gives

FnlMomCM new.pngMolMomCM new.png

Angular Distribution in the Lab Frame

FnlTheta.pngMolTheta.png


Angular Distribution in the Center of Mass Frame

FnlThetaCM.pngMolThetaCM.png

Comparing experimental vs. theoretical for Møller differential cross section 11GeV

Using the equation from [1]

[math]\frac{d\sigma}{d\Omega}=\frac{ e^4 }{8E^2}\left \{\frac{1+cos^4\frac{\theta}{2}}{sin^4\frac{\theta}{2}}+\frac{1+sin^4\frac{\theta}{2}}{cos^4\frac{\theta}{2}}+\frac{2}{sin^2\frac{\theta}{2}cos^2\frac{\theta}{2}} \right \}[/math]


where [math]\alpha=\frac{e^2}{\hbar c}\quad with\quad \hbar = c =1[/math]


This can be simplified to the form


[math]\frac{d\sigma}{d\Omega}=\frac{ \alpha^2 }{4E^2}\frac{ (3+cos^2\theta)^2}{sin^4\theta}[/math]

Plugging in the values expected for a scattering electron:



[math]\alpha ^2=5.3279\times 10^{-5}[/math]


[math]E\approx 53 MeV[/math]


Using unit analysis on the term outside the parantheses, we find that the differential cross section for an electron at this momentum should be around

[math]\frac{5.3279\times 10^{-5}}{4\times 2.81\times 10^{15}eV^2}=4.74\times 10^{-21} eV^{-2}=\frac{4.74\times 10^{-21}}{1eV^2}\times \frac{1\times 10^{18}eV^2 }{1\ GeV^2}=\frac{.0047}{GeV^2}[/math]

Using the conversion of


[math]\frac{1}{1GeV^2}=.3894 mb[/math]


[math]\frac{1\ GeV^{-2}}{.3894\ mb}=\frac{.0047\ GeV^{-2}}{x\ mb}[/math]

We find that the differential cross section scale is [math]\frac{d\sigma}{d\Omega}\approx 1.8\times 10^{-3}mb=1.8\mu b[/math]


Converting the number of electrons to barns,

[math]L=\frac{i_{scattered}}{\sigma} \approx i_{scattered}\times \rho_{target}\times l_{target}[/math]


where ρtarget is the density of the target material, ltarget is the length of the target, and iscattered is the number of incident particles scattered.


[math]\rho_{target}\times l_{target}=\frac{70.85 kg}{1 m^3}\times \frac{1 mole}{2.02 g} \times \frac{1000g}{1 kg} \times \frac{6\times10^{23} atoms}{1 mole} \times \frac{1m^3}{(100 cm)^3} \times \frac{1 cm}{ } \times \frac{10^{-24} cm^{2}}{barn} =2.10\times 10^{-2} barns[/math]


[math]\frac{1}{\rho_{target}\times l_{target} \times 4\times 10^7}=1.19\times 10^{-6} barns[/math]

FnlThetaCM.pngTheory new.png


Combining these plots, and rescaling the Final Theta in the Center of Mass for micro-barns, we find


XSect new zoom.png

Step 2

Replace the LH2 target with an NH3 target and compare with LH2 target.


FnlMomNH3.pngMolMomNH3.png

The Moller Momentum plot for higher momenta run to increase the number of values

Full MolMom.png


FnlMomNH3CM.pngMolMomNH3CM.png


FnlThetaNH3.pngMolThetaNH3.png


FnlThetaNH3CM.pngMolThetaNH3CM.png



LH2 Vs. NH3

[math]L=\frac{870 kg}{1 m^3}\times \frac{1 mole}{17.03 g} \times \frac{1000g}{1 kg} \times \frac{6\times10^{23} atoms}{1 mole} \times \frac{1cm}{100 cm} \times \frac{1 m}{ } \times \frac{10^{-23} m^2}{barn} =2.10\times 10^{-2} barns[/math]

DualFnlMom.pngDualMolMom.png


DualFnlTheta.pngDualMolTheta.png

Figure out the offset

Rerunning the GEANT simulation for a target of solo atoms of Carbon 12, with 410 incident 11GeV electrons


3setsMom.png3targets.png

Density of target material:

C=2.26 g/cm3

NH3=.86g/cm3

LH2=.07g/cm3

Altering the density of LH2 to be .86g/cm3 we find

MolThetaMod4.png


Comparing this to the theoretical differential cross section:

As shown above

We find that the differential cross section scale is [math]\frac{d\sigma}{d\Omega}\approx 1.8\times 10^{-3}mb=16.2\mu b[/math]


Converting the number of electrons to barns,

[math]L=\frac{i_{scattered}}{\sigma} \approx i_{scattered}\times \rho_{target}\times l_{target}[/math]


where ρtarget is the density of the target material, ltarget is the length of the target, and iscattered is the number of incident particles scattered.

For Carbon:

[math]\rho_{target}\times l_{target}=\frac{2.26 g}{1 cm^3}\times \frac{1 mole}{12.0107 g} \times \times \frac{6\times10^{23} atoms}{1 mole} \times \frac{1 cm}{ } \times \frac{10^{-24} cm^{2}}{barn} =1.13\times 10^{-1} barns[/math]


[math]\frac{1}{\rho_{target}\times l_{target} \times 4\times 10^7}=1.19\times 10^{-7} barns[/math]

Step 3

Determine impact of Solenoid magnet on Moller events

Papers used

[1]Farrukh Azfar's Derivation of Moller Scattering

File:FarrukAzfarMollerScatter.pdf

A polarized target for the CLAS detector

File:PHY02-33.pdf

An investigation of the spin structure of the proton in deep inelastic scattering of polarized muons on polarized protons

File:1819.pdf

QED Radiative Corrections to Low-Energy Moller and Bhabha Scattering

http://arxiv.org/abs/1602.07609

Moller Track Reconstruction

DV_MollerTrackRecon

EG12