Lab 10 RS
Lab 10 Unregulated power supply
Use a transformer for the experiment.
here is a description of the transformer.
File:TF EIM 241 transformer.pdf
Half-Wave Rectifier Circuit
1.)Consider building circuit below.
Determine the components needed in order to make the output ripple have a [math]\displaystyle{ \Delta V }[/math] less than 1 Volt.
The output ripple can be found by [math]\displaystyle{ \Delta V=\frac{I\Delta t}{C} }[/math]
I have used the following components:
[math]\displaystyle{ R_L = 96.9\ k\Omega }[/math] [math]\displaystyle{ \Delta t = 17\ ms }[/math] [math]\displaystyle{ C = 2.2\ uF }[/math]
List the components below and show your instructor the output observed on the scope and sketch it below.
Full-Wave Rectifier Circuit
Determine the components needed in order to make the above circuit's output ripple have a [math]\displaystyle{ \Delta V }[/math] less than 0.5 Volt.
List the components below and show your instructor the output observed on the scope and sketch it below.
Go Back to All Lab Reports Forest_Electronic_Instrumentation_and_Measurement