CAEN V1495 IO
Manual
Media:CAEN_V1495_Manual_Rev6.pdf
Readout code
V1
The ZIP file below contains the HDL source code to download into the V1495
http://www.physics.isu.edu/~tforest/DAQ/GEMReadout_V1495Source_Rev1_0.zip
The ZIP file below contains the ROC library
http://www.physics.isu.edu/~tforest/DAQ/GEMReadout_VxWorkxSource_11_26_2008.zip
ROC lib
compile library
To compile the ROC library I executed the following command within the subdirectory containing the v1495.c file
ccppc -fno-builtin -fno-for-scope -fstrength-reduce -mlongcall -mcpu=604 -DCPU=PPC604 -DVXWORKS -D_GNU_TOOL -DVXWORKSPPC -I/usr/local/coda/2.5/common/include/ -I../h -c -o v1495Lib.o -i v1495.c
load library onto the ROC
I then copies the library v1495Lib.o into my ROC library subdirectory which is where the ROC is pooing at boot up
/home/daq/CODA/ROClibs/libs
I loaded the library by hand by typing the following at the ROC console
-> ld < v1495Lib.o value = 268430512 = 0xfffecb0
Setting address
The address pins on this module are not labeled so I adopted the convention of numbering them from left to right as I look from the front pannel.
| Address | |
| Pin | Setting |
| SW 3 | 3 |
| SW 4 | 2 |
| SW 7 | 1 |
| SW 8 | 1 |
probing memory
I set the switches as follows
sw3 sw4 sw7 sw8
0 8 1 1
And the following is a printout of my board:
(0x80118000 - A32 0x90118000 - A24)
-> m 0x80118000
80118000: 0000-
80118002: 0000-
80118004: 0000-
80118006: 00dd-
80118008: 001f-
8011800a: ffff-
8011800c: 0002-
8011800e: 0001-
80118010: 00ff-
80118012: 0001-
80118014: 00ff-
80118016: 0001-
80118018: 0000-
8011801a: ffff-.
value = 1 = 0x1
-> m 0x90118000
90118000: 0000-
90118002: 0000-
90118004: 0000-
90118006: 00dd-
90118008: 001f-
9011800a: ffff-
9011800c: 0002-
9011800e: 0001-
90118010: 00ff-
90118012: 0001-
90118014: 00ff-
90118016: 0001-
90118018: 0000-
9011801a: ffff-.
value = 1 = 0x1
->
Download Firmware
v1495firmware(0x90118000,"GEMReadout.rbf",0,0)
Go back VME_modules Go back