Charge Collector Design
The charge collector for the Qweak chambers will use concentric strips aligned with the electron scattering polar angle () (shown as the top layer below in read) and radial strips (shown as the bottom layer in blue). The radial strip are not aligned with phi due to the expected phi symmetry. Six, 130 pin output connectors will be used. Two of the pins are ground and 128 carry signals from individual strips. The PCboard design oftware had trouble displaying the entire readout board at once such that you could see enough detail. The two pictures below represent the Top and Bottom halfs of the readout board. A view of the entire board can be seen using a Gerber file viewer. The picture of the top and Bottom layers can be found here ReadoutBoardGerberFiles along with links to the gerber files themselves.
The Top Half of the Charge Collector
This is the bottom half of the charge collector
A close up view of the 130 pin pads which will be used to mount connects for the VFAT cards.
The main web page for the connectors is at
[1]