CaGaS Phase II

From New IAC Wiki
Revision as of 22:03, 7 September 2022 by Harpconn (talk | contribs)
Jump to navigation Jump to search

CaGaS Phase II is a repeat of capture gamma energy spectroscopy experiments performed during the summer of 2021 in the ISU clean room. The purpose of revisiting the capture gamma experiment is to use a new, higher activity 252Cf source (U2-622) and to investigate different thicknesses of Gadolinium foils and the effect on the high energy photon flux produced. This work is being performed in support of the main conversion process for the In-Situ Positron Annihilation Spectroscopy experiment being designed and performed by INL staff and external collaborators.

Impromptu To Do List

  • Investigate the difference with/out PUR (pile up rejection) enabled on spec amp
    • Look for differences with high count rate source
  • Build shielded tunnel for Gd optimal thickness measurements
    • Both Gd powder and foils
    • Design and print holders for foils and powder
    • Measure up as close to Gd as possible and then ~12" away to calculate the adjustment factors necessary for coincidences

I) CaGaS Phase II Associated Equipment and Experimental Setup

Polyethylene

CH_Poly_Density

Radioactive Sources

CH Cf252 Sources

CH Calibration Sources

Electronics Chain

CH_HPGe_Electronics_Chain

II) Neutron Attenuation Measurements

Discriminator Dual Pulsing Investigation

CH Discriminator Dual Pulsing

Initial Measurements

CH He3 Attenuation Measurements

Revisited Measurements

CH He3 Attenuation Measurements: 3 Different Cf252 Sources

III) CaGaS Phase I Expansion

CaGaS Phase I Gadolinium

CaGaS Phase I Cadmium

IV) HPGe Measurements

PAS HPGe Detector

CH HPGe Efficiency

Previous Work

CaGaS Phase I

Useful Resources

CH ROOT Nonuniform Binning

CH_PAS_Master_Logbook

CH_Isotope_Table

CH_Reading_CODA_Data

CH NIM Bin Repair

Previous Page

PAS Experiment