R1 S6 SignalSearchLog: Difference between revisions
Jump to navigation
Jump to search
| Line 95: | Line 95: | ||
|- | |- | ||
| || || U18 || ||Noise. | | || || U18 || ||Noise. | ||
[[File:U18_SV_1289_Noise.png]] | [[File:U18_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U33 || ||Noise. | | || || U33 || ||Noise. | ||
[[File:U33_SV_1289_Noise.png]] | [[File:U33_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U34 || ||Noise. | | || || U34 || ||Noise. | ||
[[File:U34_SV_1289_Noise.png]] | [[File:U34_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U49 || ||Noise. | | || || U49 || ||Noise. | ||
[[File:U49_SV_1289_Noise.png]] | [[File:U49_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U50 || ||Noise. | | || || U50 || ||Noise. | ||
[[File:U50_SV_1289_Noise.png]] | [[File:U50_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U60 || ||Hot. | | || || U60 || ||Hot. | ||
[[File:U60_SV_1289_HOT.png]] | [[File:U60_SV_1289_HOT.png|200px]] | ||
|- | |- | ||
| || || U65 || ||Noise. | | || || U65 || ||Noise. | ||
[[File:U65_SV_1289_Noise.png]] | [[File:U65_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U66 || ||Noise. | | || || U66 || ||Noise. | ||
[[File:U66_SV_1289_Noise.png]] | [[File:U66_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U81 || ||Noise. | | || || U81 || ||Noise. | ||
[[File:U81_SV_1289_Noise.png]] | [[File:U81_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U82 || ||Noise. | | || || U82 || ||Noise. | ||
[[File:U82_SV_1289_Noise.png]] | [[File:U82_SV_1289_Noise.png|200px]] | ||
|- | |- | ||
| || || U88 || ||Hot. | | || || U88 || ||Hot. | ||
[[File:U88_SV_1289_HOT.png]] | [[File:U88_SV_1289_HOT.png|200px]] | ||
|- | |- | ||
| || || U89 || ||Hot. | | || || U89 || ||Hot. | ||
[[File:U89_SV_1289_HOT.png]] | [[File:U89_SV_1289_HOT.png|200px]] | ||
|} | |} | ||
Revision as of 23:14, 9 May 2013
Testing procedure
Things that may cause "noise" that are actually due to your testing setup:
- STB boards not securely attached to chamber. Make sure center screws (ones attaching directly to the chamber, not the nylon stand-offs) are tightened to 14 in. lb's.
- Scope's termination set to 1Mohm. Set the scope to 50ohm termination.
- Lower bandwidth of 1 Ghz scope to 200 Mhz. This attenuates peak height, but also rejects high frequency noise and reduces the noise level from 55-65 mV to ~11-15 mV.
Super Layer 1
STB-1 G1202220
| Layer | Wire | Channel | Date | Comments |
| U1 | This channel presents higher noise level than the other ones, which makes difficult to get a signal with amplitude below 30mV. This behaviour extends to all the first channels of each connector in the board. however, if a high enough trigger level is set in the scope(~40mV), it is always possible to get a signal in these channels.
| |||
| U24 | Warm Wire: This is a channel that always triggers a fake signal.
| |||
| U38 | Warm Wire.
| |||
| U66 | HOT Wire: This is a channel that always triggers a fake signal very often.
| |||
| U87 | HOT Wire.
| |||
| U93 | HOT Wire.
|
The rest of channels not mention here has a similar behaviour between them, with a noise level not greater than ~20mV.
STB-2 G1202266
| Layer | Wire | Channel | Date | comments |
| U38 | Hot wire.
| |||
| U40 | Warm wire.
| |||
| U51 | Hot wire.
| |||
| U65 | Hot wire.
|
STB-3 G1202273
| Layer | Wire | Channel | Date | comments |
| U1 | Hot wire.
| |||
| U2 | Hot wire.
| |||
| U39 | Hot wire.
| |||
| U78 | Hot wire.
|
STB-4 G1202275
| Layer | Wire | Channel | Date | comments |
| U15,U21,U28 | This Board presents a unusual noise in all the channels. The noise is a big positive spark, which makes difficult the recolection of signals. However, It was possible by setting a higher trigger level in the scope.
| |||
| U61 | Hot and Noisy.
|
STB-5 G1202271
| Layer | Wire | Channel | Date | comments |
| U08 | Hot and Noisy.
| |||
| U17 | Noise.
| |||
| U18 | Noise.
| |||
| U33 | Noise.
| |||
| U34 | Noise.
| |||
| U49 | Noise.
| |||
| U50 | Noise.
| |||
| U60 | Hot.
| |||
| U65 | Noise.
| |||
| U66 | Noise.
| |||
| U81 | Noise.
| |||
| U82 | Noise.
| |||
| U88 | Hot.
| |||
| U89 | Hot.
|
STB-6
| Layer | Wire | Date | comments |
STB-7
| Layer | Wire | Date | comments |
Super Layer 2
STB-1
| Layer | Wire | Date | comments |
STB-2
| Layer | Wire | Date | comments |
STB-3
| Layer | Wire | Date | comments |
STB-4
| Layer | Wire | Date | comments |
STB-5
| Layer | Wire | Date | comments |
STB-6
| Layer | Wire | Date | comments |
STB-7
| Layer | Wire | Date | comments |