Difference between revisions of "Reproducibility Shots July 2017"
Jump to navigation
Jump to search
| Line 5: | Line 5: | ||
I have overlaid X and Y profiles as well as created 3D renderings of the beam profile for the front and back sets of OSLs. Note that it is flat due to the distance at which the board was placed from the end of the accelerator. | I have overlaid X and Y profiles as well as created 3D renderings of the beam profile for the front and back sets of OSLs. Note that it is flat due to the distance at which the board was placed from the end of the accelerator. | ||
| − | [[File:Shot 1 Front Jul2017.png|400px|thumb| | + | [[File:Shot 1 Front Jul2017.png|400px|thumb|left|*Unknown calibration on OSL reader]] |
| + | [[File:Shot 1 Back Jul2017.png|400px|thumb|center|*Unknown calibration on OSL reader]] | ||
Revision as of 18:49, 25 July 2017
Shot 1
In this experiment, I picked 17 different points on my OSL board to test agreement between two OSLs at the same physical location for the same shot from TriMeV.
I have overlaid X and Y profiles as well as created 3D renderings of the beam profile for the front and back sets of OSLs. Note that it is flat due to the distance at which the board was placed from the end of the accelerator.
