X-pinch driver 2-bricks fabrication

[go back]

12/10/13

• brick housing (BH) parts (steel/PMMA) drawings approved by Spielman (drawings #2013.1.001.0002-0009)

12/11/13

• VSM Technologies selected as manufactured company for BH parts (drawings #2013.1.001.0002-0009)

12/17/19

• BH parts arrived at IAC and inspected. Kevin is going to assemble and weld them all together.

12/18/19

• Cathode/anode drawings submitted to Spielman for approving (drawings #2013.1.001.0010-0017)
• PMMA_Output_Sheet/Charging_Isolating_Tube drawings submitted to Spielman for approving (drawings #2013.1.001.0018-0019)
• Assembly drawing with included cathode/anode submitted to Spielman for approving (drawing #2013.1.001.0020)

12/19/13

• LESKER reduced 4-way cross (C-0800-275, $890) found as candidate for vacuum chamber
• LESKER reduced 4-way cross drawing downloaded and incorporated into SolidWorks (assembly file Lesker_C-800_275\C-0800-275 reassembled)
• LESKER reduced 4-way cross redesigned to match our x-pinch driver (drawing file Lesker_C-800_275\LESKER_C-0800-275_REASSEMBLED)

12/20/13

• • Some changes to parts have been done to accommodate cross drawing:
    • 1) inner cut increased from 4.5 diameter to 10" diameter to match the cross (drawing #2013.1.001.0010-0008);
    • 2) anode can slot size increase from 0.4" to 0.5" to march x-pinch wires length (drawing #2013.1.001.0014);
• LESKER C-0800-275 REASSEMBLED drawing submitted to Spielman for approving (drawing LESKER C-0800-275 REASSEMBLED)
• The assembly drawing with included cathode/anode/cross submitted to Spielman for approving (drawing #2013.1.001.0010-0021)