Difference between revisions of "HRRL Dec 19 2012Run"

From New IAC Wiki
Jump to navigation Jump to search
Line 1: Line 1:
 
  
 
= Tune =
 
= Tune =
Line 19: Line 18:
 
| Rep Rate    ||  
 
| Rep Rate    ||  
 
|-
 
|-
|  Gun HV  ||   (Knob Setting)
+
|  Gun HV  || 10 (Knob Setting)
 
|-
 
|-
|  Gun Grid Voltage  ||   (Knob Setting)
+
|  Gun Grid Voltage  || 10  (Knob Setting)
 
|-
 
|-
|  RF frequency  || MHz
+
|  RF frequency  || MHz
 
|-
 
|-
|  Modulator HV Power Supply  ||   (Knob Setting)
+
|  Modulator HV Power Supply  || 4.30  (Knob Setting)
 
|-
 
|-
 
|  RF macro Pulse Length (FWHM)  || 300 ns
 
|  RF macro Pulse Length (FWHM)  || 300 ns
Line 41: Line 40:
 
|Q6  (A)||  
 
|Q6  (A)||  
 
|-
 
|-
| Current at FC0 || mA
+
| Current at FC0 ||   mA
 
|}
 
|}
  
  
  
= Radiation on the hole way =
+
= Radiation on the hall way =
  
 
== Alutia Radiation Test  ==
 
== Alutia Radiation Test  ==

Revision as of 15:12, 20 December 2012

Tune

Energy Switch Out (High En)
Solenoid 1 A
Solenoid 2 A
Gun Hor A
Gun Ver A
Output Hor A
Output Ver A
Rep Rate
Gun HV 10 (Knob Setting)
Gun Grid Voltage 10 (Knob Setting)
RF frequency MHz
Modulator HV Power Supply 4.30 (Knob Setting)
RF macro Pulse Length (FWHM) 300 ns
Q1 (A)
Q2 (A)
Q3 (A)
Q4 (A)
Q5 (A)
Q6 (A)
Current at FC0 mA


Radiation on the hall way

Alutia Radiation Test

Alutia is placed in experimental cell side to look at the radiation coming from hall way.


Full Current

300 Hz reprate

300 ns pulse width

Beam is on FC0

CH4 (Green) Alutia

Ch1 (Yellow) FC0

runs

run# T1 T2 Sweep Magnet logic HV NaI Left (CH3) (Det#1) HV NaI R Right (CH9) (Det#2) Dis Threshold Left Dis Threshold Right Reprate start stop Run time (s) Int Rate comments event pulses
4623 in in out (DL & GunTrig) & (DR & GunTrig) 1100V 1190V 5 mV 5 mV 300 16:43:26 16:: events/s beam pulses

Source runs

Run # Source logic Run starts Run ends HV NaI Left (CH3) (Det#1) HV NaI R Right (CH9) (Det#2) Spectrum
4624 Na22 NaI Right && NaI Left 1100 V 1190 V 19:42:36 Dec19