Charge Collector Design

The charge collector for the Qweak chambers will use concentric strips aligned with the electron scattering polar angle ([math]\theta[/math]: the Z-axis is pointing along the beam direction), shown as the top layer below in read, and radial strips (shown as the bottom layer in blue). The radial strip are not aligned with phi due to the expected phi symmetry. Six, 130 pin output connectors will be used. Two of the pins are ground and 128 carry signals from individual strips.

Latest Design 12/07

Bottom Copper Layer

Internal radius: 69.7mm

External radius: 313.9mm

Circular lines width: 0.4mm Media:QweakGEMchargeCollectorBottom.pdf

Top Copper Layer

line width: 0.1mm

Media:QweakGEMchargeCollectorTop.pdf

Connector pads view

Preliminary design 6/07

The PCboard design software had trouble displaying the entire readout board at once such that you could see enough detail. The two pictures below represent the Top and Bottom halfs of the readout board. A view of the entire board can be seen using a Gerber file viewer. The picture of the top and Bottom layers can be found here ReadoutBoardGerberFiles along with links to the gerber files themselves.

The Top Half of the Charge Collector showing all six output conenctors

This is the bottom half of the charge collector showing only the bottom 2 output connectors

A close up view of the 130 pin pads which will be used to mount connectors for the VFAT cards.

We need to have plated holes which allow the copper lines to pass through to the very last layer where the copper pads for the 130 pin connector are.

The main web page for the connectors is at [1]

Taget3001_GerberFileProblem Target 3001 design software