Difference between revisions of "June, 7, 2007 Cf rate measurements using Photonics PMT"
Jump to navigation
Jump to search
Line 18: | Line 18: | ||
! Configuration || Rate (counts/min) | ! Configuration || Rate (counts/min) | ||
|- | |- | ||
− | | 1 || 0 | + | | 1 || 0 || |
|- | |- | ||
| 2 || 0 | | 2 || 0 |
Revision as of 21:17, 7 June 2007
Cf source was placed X cm away from face of PHotonics PMT. The PMT output signal was descriminated by a Lecroy Model # YYY descriminator set to pass any voltage below -0.5 mV. The descriminated output was then sent to a scaler Model ####.
Configuration Definitions
1: Placed the Cf source ## cm from face of Scintillator. neutrons passing through scintillator would also pass through PMT
2: Inserted a ### cm thick steel shielding wall between Scintillator and Cf source. Right up against Scintillator
3: Replaced steel wall with ### cm thick lead shielding brick
4: Replaced lead brick with ### cm thick parafin block
5: Increased thickness of parafin block to #### cm
Configuration | Rate (counts/min) | |
---|---|---|
1 | 0 | |
2 | 0 | |
3 | 0 | |
4 | 0 | |
5 | 0 |