Difference between revisions of "Lab 10 TF EIM"
Jump to navigation
Jump to search
| (3 intermediate revisions by the same user not shown) | |||
| Line 8: | Line 8: | ||
[[File:TF_EIM_241_transformer.pdf]] | [[File:TF_EIM_241_transformer.pdf]] | ||
| + | [[File:IN5230-B-T_DataSheet.pdf]] | ||
=Half-Wave Rectifier Circuit= | =Half-Wave Rectifier Circuit= | ||
| Line 17: | Line 18: | ||
Determine the components needed in order to make the output ripple have a <math>\Delta V</math> less than 1 Volt. | Determine the components needed in order to make the output ripple have a <math>\Delta V</math> less than 1 Volt. | ||
| − | List the components below and show your instructor the output observed on the scope. | + | List the components below and show your instructor the output observed on the scope and sketch it below. |
=Full-Wave Rectifier Circuit= | =Full-Wave Rectifier Circuit= | ||
| Line 24: | Line 25: | ||
Determine the components needed in order to make the above circuit's output ripple have a <math>\Delta V</math> less than 0.5 Volt. | Determine the components needed in order to make the above circuit's output ripple have a <math>\Delta V</math> less than 0.5 Volt. | ||
| − | List the components below and show your instructor the output observed on the scope. | + | List the components below and show your instructor the output observed on the scope and sketch it below. |
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
| − | |||
[[Forest_Electronic_Instrumentation_and_Measurement]] | [[Forest_Electronic_Instrumentation_and_Measurement]] | ||
Latest revision as of 20:22, 4 March 2011
Unregulated power supply
Use a transformer for the experiment.
here is a description of the transformer.
File:TF EIM 241 transformer.pdf
Half-Wave Rectifier Circuit
1.)Consider building circuit below.
Determine the components needed in order to make the output ripple have a less than 1 Volt.
List the components below and show your instructor the output observed on the scope and sketch it below.
Full-Wave Rectifier Circuit
Determine the components needed in order to make the above circuit's output ripple have a less than 0.5 Volt.
List the components below and show your instructor the output observed on the scope and sketch it below.